Advertisement
Quick Links
Advertisement
Related Manuals for Workrite Ergonomics Sierra HX
Summary of Contents for Workrite Ergonomics Sierra HX
- Page 1 Workrite Sierra HX & HXL ™ ™ Assembly Instructions for 3-leg Electric Workcenters #1500216- Rev C...
-
Page 2: Parts, Sold Separately
Workrite Sierra HX & HXL Electric Workcenters - Assembly Instructions for 3-leg Tables List of Parts, grouped by carton Rear Bracket* #8 × ⅝" Pan Head Short Bracket Qty: 2 Screw Qty: 4 Qty: 13 Left End Bracket * Lengths will vary depending on model... - Page 3 Workrite Sierra HX & HXL Electric Workcenters - Assembly Instructions for 3-leg Tables Verify that you have all the hardware and tools needed for the assembly. Check your cartons against the list on page 2 to verify that you have all the parts needed. You will...
- Page 4 Workrite Sierra HX & HXL Electric Workcenters - Assembly Instructions for 3-leg Tables Position Leg Assembly and Drill Pilot Holes for Non-Workrite Worksurfaces If you have a Workrite worksurface skip to step If you do not have a Workrite worksurface:...
- Page 5 Workrite Sierra HX & HXL Electric Workcenters - Assembly Instructions for 3-leg Tables Attach Feet (sold separately) & Glides Attach Feet (H & U) to bottom of legs with Flat Head Cap Screws (J), using Allen Wrench (L) and tighten securely. Be sure the longer end of the foot goes towards the front of the table.
- Page 6 Workrite Sierra HX & HXL Electric Workcenters - Assembly Instructions for 3-leg Tables Attach Control Box & Cable Spools to Tabletop Position Control Box (O). If you have a Workrite tabletop: Locate the two pilot holes for the Control Box and proceed to Step...
- Page 7 Workrite Sierra HX & HXL Electric Workcenters - Assembly Instructions for 3-leg Tables Attach Switch If you have a Workrite worksurface: Position the Switch (M) over the pilot holes near front edge of worksurface. If you do not have a Workrite worksurface: Align Switch (N) so that outermost edge of switch is flush with edge of worksurface. Pre-drill screw...
- Page 8 Workrite Sierra HX & HXL Electric Workcenters - Assembly Instructions for 3-leg Tables Connect Cables to Legs and Control Box Connect both of the 1 meter Leg Cables (P) to both the Legs (G) nearest the Control Box. Connect the 2 meter Leg Cable (T) to the Leg furthest from the Control Box.
-
Page 9: Cleaning Instructions
Workrite Sierra HX & HXL Electric Workcenters - Assembly Instructions for 3-leg Tables Connect Power Cord to the Power Supply and Put NOTE: Manage your cables using the provided spools and clips to prevent Workcenter Upright entanglements and avoid obstructions or damage. - Page 10 Workrite Sierra HX & HXL Electric Workcenters - Assembly Instructions for 3-leg Tables 10 of 10 Workrite Ergonomics | 800.959.9675 www.workriteergo.com...
Need help?
Do you have a question about the Sierra HX and is the answer not in the manual?
Questions and answers