Related Manuals for Spektrum DXS
Summary of Contents for Spektrum DXS
- Page 1 Spektrum DXS and AR410 4 CH Receiver Spektrum DXS und AR410-Empfänger mit 4 Kanälen Spektrum DXS et récepteur AR410 4 canaux Spektrum DXS e ricevitore AR410 a 4 canali...
- Page 2 WARNING AGAINST COUNTERFEIT PRODUCTS Always purchase from a Horizon Hobby, LLC authorized dealer to ensure authentic high-quality Spektrum product. Horizon Hobby, LLC disclaims all support and warranty with regards, but not limited to, compatibility and performance of counterfeit products or products claiming compatibility with DSM or Spektrum technology.
-
Page 3: Table Of Contents
4-Channel receiver (SPM1010). The DXS transmitter and AR410 receiver are each fully compatible with other Spektrum DSMX systems. The DXS transmitter has a default configuration that is designed to work with SAFE technology; a 3-position switch for Flight Modes on Channel 5, and a ®... -
Page 4: Specifications
Specifications DXS TRANSMITTER SPMR1010 Type DSMX 7 CH Transmitter 1 Momentary Button, 2 3-Position Switch, Auxiliary Switches and Buttons 2 2-Position Switches Channels Power Supply 4 AA Batteries Control Mode Mode 2 Telemetry Flight Battery Voltage (Smart ESC required) Wireless; Remote Receiver SPM9747 Required Com-... -
Page 5: Transmitter Diagram
Transmitter Diagram Antenna B Switch (Ch 5 Default) D Switch (Ch 7 Default) RGB LED H Switch (Throttle Cut Default) F Switch (Dual Rate Default) 4 Green LEDs Throttle/Rudder Gimbal (Mode 2) Elevator/Aileron Gimbal (Mode 2) Aileron Trim (Mode 2) Elevator Trim (Mode 2) Power Button Neck Strap Hook... -
Page 6: Installing The Transmitter Batteries
Channel 3 (Elevator) Channel 4 (Rudder) IMPORTANT: When using Y-harness or servo extensions with Spektrum equipment, do not use reversing harnesses. Using reversing Y-harnesses or servo extensions may cause servos to operate erratically or not function at all. Receiver Installation Install the receiver as recommended by your airplane’s manufacturer and... -
Page 7: Binding
Binding The DXS and your receiver must be bound to each other before they will operate. Binding is the process of teaching the receiver the specific code of the transmitter so it will only connect to that specific transmitter. 1. Push and hold the bind button on the receiver while powering ON the receiver. - Page 8 Factory Reset: Power the transmitter on while holding the sticks down and outward. The transmitter will emit a series of beeps and revert to factory settings. IMPORTANT: Factory reset will restore all settings to factory default, losing any settings programmed in the DXS.
-
Page 9: Setting Failsafe On The Ar410 Receiver
4 Press the A button on the transmitter and power it ON. Preset Failsafe 1 Move all sticks and switches on the DXS to the desired failsafe positions 2 Push and hold the bind button on the AR410 and then power it ON 3 Release the button once the LED begins to flash 4 Push and Hold the Bind Button on the receiver during the rest of the bind process. -
Page 10: Led Smart Battery Usage
Land the aircraft when the alarm sounds. After landing, reset the Smart Battery low voltage warning by either (1) powering cycling the DXS transmitter, or (2) disconnecting the battery from the aircraft for more than 15 seconds or until the LED voltage indication bars go out. -
Page 11: Adjust Stick Tension
Changing the Throttle Ratchet 1. Remove the batteries from the transmitter. 2. Remove the six Phillips head screws that secure the rear transmitter case half. 3. Put the transmitter face down on a piece of foam or a towel and remove the rear case. NOTICE: Do not pull or disconnect any of the wires attached to the back transmitter half or damage may result. - Page 12 Troubleshooting Guide Problem Possible Cause Solution Throttle not at idle and/or throttle trim Reset controls with throttle stick and throttle Aircraft too high trim at lowest setting will not Make sure throttle servo travel is 100% respond to Throttle servo travel is lower than 100% or greater throttle but responds...
-
Page 13: 1-Year Limited Warranty
1-Year Limited Warranty What this Warranty Covers - Horizon Hobby, LLC, (Horizon) warrants to the original purchaser that the product purchased (the “Product”) will be free from defects in materials and workmanship for a period of 1 year from the date of purchase. What is Not Covered - This warranty is not transferable and does not cover (i) cosmetic damage, (ii) damage due to acts of God, accident, misuse, abuse, negligence, commercial use, or due to improper use, installation, operation or... -
Page 14: Warranty And Service Contact Information
be included, but are not designed to withstand the rigors of shipping without additional protection. Ship via a carrier that provides tracking and insurance for lost or damaged parcels, as Horizon is not responsible for merchandise until it arrives and is accepted at our facility. An Online Service Request is available at http:// www.horizonhobby.com/content/_service-center_render-service-center. -
Page 15: Compliance Information For United States
2.400GHz to 2.4835GHz frequency range. When operating your Spektrum receiver, please be sure to maintain a separation distance of at least 20 cm between your body (excluding fingers, hands, wrists, ankles and feet) and the antenna to meet RF exposure safety requirements as determined by FCC regulations. -
Page 16: Compliance Information For Canada
Compliance Information for Canada IC Information DXS Transmitter IC: 6157A-KATY1T AR410 Receiver IC: 6157A-TASPMAR410 CAN ICES-3 (B)/NMB-3(B) This device complies with ISED Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, Including interference that may cause undesired operation of the device. - Page 17 © 2020 Horizon Hobby, LLC. DSM, DSM2, DSMX, Spektrum Airware, SRXL2, SmartSafe, Hangar 9 and the Horizon Hobby logo are trademarks or registered trademarks of Horizon Hobby, LLC. The Spektrum trademark is used with permission of Bachmann Industries, Inc. JR is a registered trademark of JR Americas. All other trademarks, service marks and logos are property of their respective owners.
Need help?
Do you have a question about the DXS and is the answer not in the manual?
Questions and answers