Table of Contents
Advertisement
Q-Logic™ Joystick Setup
Center Deadband
1.
Plug the Q-Logic handheld programmer into the back of the display.
2.
On the programmer, select Program Adjustments.
3.
In the Program Adjustments menu, select Enhanced Display.
4.
In the Enhanced Display menu, with the Up and Down buttons,
5.
In the Proportional Input folder, select Center Dedband.
6.
With the Plus and Minus buttons ±, adjust the center deadband value.
7.
Use the Left navigation button
Tremor Suppression
1.
Plug the Q-Logic handheld programmer into the back of the display.
2.
On the programmer, select Program Adjustments.
3.
In the Program Adjustments menu, select Enhanced Display.
4.
In the Enhanced Display menu, with the Up and Down buttons,
5.
In the Proportional Input folder, select Tremor Suppression.
6.
With the Plus and Minus buttons ±, adjust the tremor suppression value.
7.
Use the Left navigation button
Switch Operation
1.
Plug the Q-Logic handheld programmer into the back of the display.
2.
On the programmer, select Program Adjustments.
3.
In the Program Adjustments menu, select Enhanced Display.
4.
In the Enhanced Display menu, with the Up and Down buttons, select Input
Configuration.
5.
With the Plus and Minus buttons ±, select Proportional Switch Op.
6.
Use the Left navigation button
to exit menu.
to exit menu after selections have been made.
to exit the menu after selections have been made.
select Proportional Input.
select Proportional Input.
15.0
17
Advertisement
Table of Contents
