Maintenance & Troubleshooting - Unimig U21001K Manual

MAINTENANCE &
TROUBLESHOOTING
MAINTENANCE
• The UNIMIG Welding Goggles need little maintenance. Use a clean, soft piece of cloth, moistened
with soap / commercial disinfectant to wipe the inside and the outside of the goggles then dry.
• Note: Do not immerse the UNIMIG Goggles or Mask in water directly.
TROUBLESHOOTING
PROBLEM
The goggles do not darken when welding.
The goggles stay dark after welding or if there
is no arc present.
The goggles switch during the welding.
Inconsistent shade number on the corner of
the goggles.
WARRANTY
UNIMIG is pleased to offer a 2 year warranty on the UNIMIG Welding Goggles. UNIMIG offers warranty
across Australia with four UNIMIG service area's in Sydney, Melbourne, Brisbane & Perth. We also
have authorised service centres across Australia as well. UNIMIG's focus is to assure the buyer is
getting reliability, performance and peace of mind.
0477 GOGGLES Manual APR20 v8.indd 13 0477 GOGGLES Manual APR20 v8.indd 13
RESOLUTION
• Stop welding or cutting immediately.
• Make sure the sensors are facing the arc and
no obstructions.
• Check the mode that is on WELD, not GRIND.
• Review sensitivity recommendations and
adjust sensitivity if possible.
• Replace the battery if necessary.
• Adjust the sensitivity to a lower level (Level 1).
• If the work place is extremely bright, it is
recommended to reduce the surrounding
light level.
• Increase the sensitivity if possible.
• Make sure the sensors are facing the arc and
no obstructions.
• Increase Delay 0.1 − 0.3 second may also
reduce switching.
• It is a natural feature and will not be
dangerous for the eyes.
• In order to get a maximum comfort, try to
keep a view angle at around 90°.
UNIMIG Welding Goggles Manual | 13
20/04/2020 8:17:15 AM 20/04/2020 8:17:15 AM