Download
Share
Print this page
  1. Manuals
  2. Brands
  3. SI Manuals
  4. Indoor Furnishing
  5. Nano Box
  6. Installation instructions manual

SI Nano Box Installation Instructions Manual

110v ac - 485
Hide thumbs Also See for Nano Box:

Advertisement

Quick Links

Download this manual
Nano Box
Installation Instructions
110v AC - 485
INSTALLERS: Please leave this manual with the owner.
Doc. # 400027

Advertisement

loading
Need help?

Need help?

Do you have a question about the Nano Box and is the answer not in the manual?

Questions and answers

Related Manuals for SI Nano Box

Summary of Contents for SI Nano Box

  • Page 1 Nano Box Installation Instructions 110v AC - 485 INSTALLERS: Please leave this manual with the owner. Doc. # 400027...

  • Page 3: Wall Brackets

    PARTS LIST - NANO BOX - 110v AC - 485 Shades Wall Brackets 375 Box 475 Box Screws Included Please note all the Node IDs on your Shade motors. (3 per Bracket) See the last page on these instructions. Leveling Shims (4 per shade)
  • Page 4 SPACER BLOCKS AND LEVELING SHIMS (OPTIONAL) Spacer Blocks - used to clear an obstruction in the fabric path. Connect spacer blocks to shade brackets before installation. Note: Do not use more than 4 spacer blocks per bracket. Leveling Shims - used if the window frame is out of level. Connect to shade brackets before installation Note: do not use more than 2 leveling shims per bracket.
  • Page 5 INSTALLATION - NANO BOX - 110v AC - 485 1. Terminate pre-wire with the supplied terminal block Header Not used Never connect 110v AC power to Data + the supplied terminal block. Data - Data ground 2. Install the wall brackets 4 - 6 inches in from the end of the shade with the supplied screws.
  • Page 6 INSTALLATION - NANO BOX - 110v AC - 485 3. Make sure the wall bracket lever is down (may already be down). Proper position for installing Box 4. Install terminal block bracket between jamb and wall bracket on the pre-wire side using the...
  • Page 7 INSTALLATION - NANO BOX - 110v AC - 485 6. Connect shade data cable to pre-wire and snap into terminal block bracket Data Cable Power Cable 7. Hang shade onto wall brackets and center in the opening 8. Use thumb to lock shade in place...
  • Page 8 WIRING - 485 110v AC Pre-wire Shade Connect data only. DO NOT connect 110v AC power to terminal block. Wiring - 485...
  • Page 9 PROGRAMMING - 485 RS485 shades are programmed using the Screen Innovations SIFI via the web interface. This programming can be done with a Windows or Mac computer either over LAN or wired directly to SIFI. The following instructions are for a Windows computer, but the steps for programming on a Mac are very similar.

  • Page 10: Troubleshooting - 485

    SIFI is not powered. To verify the si.fi is powered look for a green LED flashing on the board, this light will either be steady on or flashing. If no light is visible make sure power is available via the bus power supply or PoE.
  • Page 11 NODE IDS Please keep a note of all the Node IDs on your shade motors. OR for larger shade orders, refer to your Sales Order document for the list. Room Shade 1 Shade 2 Shade 3 Shade 4 Shade 5 Shade 6 Room Shade 1...
  • Page 12 Screen Innovations 9715-B Burnet Rd, Suite 400 Austin, TX 78758 512.832.6939 www.screeninnovations.com 400027 v. 1.3 12 November 2019...