Chapter 6 | Turning On Your Jordaan+ And Charging - Lekker Bikes JORDAAN+ Manual

CHAPTER 6
Turning on your Jordaan+ and
charging
We know you are excited to try your Jordaan+ for the
first time! You're nearly there, just a few more steps
before it's ready to go!
20. Before turning on your Jordaan+, we recommend
doing this whilst sitting on the bike, this allows full
control over the bike and can avoid accidents. To turn
your Jordaan+ on, using the control module found on
the left hand side of your bar, press the power button
for a few seconds to turn on your screen, once turned
on, you can then cycle through the assist modes using
the arrow buttons on the control module. For more in-
depth instructions for your screen, please refer to the
manufacturer's manual, found in PDF format online.
PLEASE NOTE: We recommend always using assist
level 1 for starting, as this will allow better control of
the bike.
MANUAL LEKKER BIKES / Jordaan+
CHAPTER 6
Turning on your Jordaan+ and
charging
To operate the lights, make sure the battery is
charged and in the bike. Power up the bike, once the
control screen has turned on hold down the plus (+)
button for 2 seconds to turn on both the front and
rear lights. To turn off the lights hold down the plus (+)
button for 2 seconds and the lights will switch off.
Hold down the "-" button for 2 secs, the motor will
then engage up to 6km/h.
21. All batteries will come with some charge, to get the
most out of your battery, you may need to charge it
before your first ride. We recommend that for the first
three charges, you charge it for 12hr cycles. PLEASE
NOTE: this will allow the battery to have full charge
capacity.
17 MANUAL LEKKER BIKES / Jordaan+ 18