Mounting Of The Connector For Series Connection (Optional) - Panasonic SF2B Series Instruction Manual

Light curtain

Hide thumbs Also See for SF2B Series:

Table of Contents

2-2-2

Mounting of the Connector for Series Connection (Optional)

For constructing the series connection, the following procedure is required.

Do not lose any screws during extension / dismantling work.

Furthermore, do not mix emitters and receivers to mount in series connection

The packing is attached to the connector of the

not attached correctly, reattach the packing as shown in the figure below, and

mount to this device.

1. Loosen the two M3 screws of the end cap on the main sensor (SF2B-□), and then remove

the end cap from the device.

2. Insert the cable for the series connection (SF2B-CSL□) into the connector of the main

sensor (SF2B-□) and the sub sensor (this device). When inserting the connector, fit the

cable into the groove of the main sensor (SF2B-□) and the sub sensor (this device).

3. Tighten each two M3 screws. The tightening torque should be 0.3N·m or less.

bottom cap cable.

If the packing is

- 15 -

Table of Contents