Section 4: Full Bed Conversion - Delta 7052 Assembly Instructions Manual

SECTION 4: Full Bed Conversion

STEP 1
This crib can be converted to a Full size Bed with the purchase of Delta Children's Products Item
0030 - Full Size Bed Rail Kit.
1. Disassemble the crib by reversing the instructions.
2. Attach the bed rails to the Footboard - Front Rail (Part B), and the Headboard - Back Rail (Part A)
following the instructions included with them. There are (8) M6x15mm Bolts (Part P) that may be
used, if directed in the instructions.
3. Install (4) M6x15mm Bolts (Part P) in the Upper holes on the back side of the Footboard
4. Install (4) M6x40mm Bolts (Part N) with (4) M6 Cap Nuts (Part S) into the upper holes on the
headboard.
5. Attach the canopy posts if desired (see Section 2 Step 1). The canopy posts are not required to
be attached (see Section 3 Step 1), install (4) M6x15mm Large Head Bolts (Part R).
6. Install the Spacers (Part L) over the top bolts in the Canopy posts.
7. Tighten the Crystal Balls (Part K) by hand on top of each Spacer.
K
L
P
S
N
14