Related Manuals for Pulsar PTG1220D5
Summary of Contents for Pulsar PTG1220D5
- Page 1 Model: PTG1220D5 Gasoline Powered Lawn Mower OPERATOR’S MANUAL support@pulsar-products.com...
- Page 2 You may contact Pulsar directly at 1-866-591-8921 for product and accessory information and help finding a dealer. To register your product please register online at: pulsar-products.com Note Propsition 65 Warning The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm.
- Page 3 • Do not operate this machine while under the influence of alcohol or drugs. Uneven terrain could cause a slip or fall resulting in severe injury. Poor footing could cause a slip or fall. the engine Disconnect the spark plug wire and ground the center electrode to a metal part of the engine.
-
Page 4: Wheel Installation
Product Specification Component Specification Rated Speed 2800RPM Displacement 150cc Cutting Width 20” Single Lever Height Adjustment Height Adjustment For Each Wheel Wheels Machine 7” Front 7” Rear Weight 61 lbs Safety & Instruction Decals Important: Safety & instruction decals are located near Figure 1 areas of potential DANGER. -
Page 5: Product Overview
4. Height Adjustment 5. Handle Loosening Knob Operation Attachments/Accessories A selection of Pulsar approved attachments and Accessories are available for use with the machine to enhance and expand its capabilities. Contact your Figure 8 Authorized Service Center or Distributor 1-866-591-8921. -
Page 6: Cutting Height Adjustment
Cutting Height Adjustment Adjusting the cutting height may bring you into contact with the moving blade, causing serious injury. • Stop the engine and wait for all the moving parts to stop. • Do not put your fingers under the housing when adjusting the cutting height. -
Page 7: Operating Tips
• Replace the blade when necessary with a genuine Pulsar replacement blade. High Altitude Operation Cutting Grass Most small engines with carburetors are designed to •... -
Page 8: Spark Plug Maintenance
Spark Plug Maintenance 1. Once the engine has cooled, remove the spark plug wire. 2. Remove the spark plug using a spark plug wrench. 3. Clean the spark plug with a wire brush (not supplied). 4. Using a feeler gauge set the gap to 0.75mm. 5. -
Page 9: Replacing The Air Filter
Replacing the Blade Replacing the Air Filter Service Interval: Yearly Service Interval: 25 Hours Important: You will need a torque wrench to install the blade properly. If you do not have a torque wrench or are 1. Lift the right-side tab to open the air filter uncomfortable performing this procedure, contact an cover.(Figure 14) Authorized Service Center. - Page 10 Leave spark plug cable disconnected. Figure 18 Storing 1. Loosen handle knobs. 2. Move handle forward and fold it as shown. • Do not store untreated gasoline longer than 30 days. • Do not store the mower in an enclosed area, near any source of ignition (flame, spark, etc) •...
-
Page 11: Warranty
Pulsar Products Inc. authorized service dealer, is found to be detective within the original warranty period. Pulsar Products Inc. will also decide upon the use of new or rebuilt parts or comparable product. Any part or product that is replaced will be retained by Pulsar Products Inc. - Page 12 Take the original receipt and product to the place of purchase or mail the original receipt and product to the address found on the web site if purchased on-line. You can also locate your nearest Pulsar Products Inc. dealer for service or warranty questions by calling toll free at 1-866-591-8921 Mon-Fri 7:00 AM to 4:00 PM Eastern Standard Time.
Need help?
Do you have a question about the PTG1220D5 and is the answer not in the manual?
Questions and answers