Advertisement

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Koven MiniDoppler ES-100VX and is the answer not in the manual?

Questions and answers

Summary of Contents for Hadeco Koven MiniDoppler ES-100VX

  • Page 2 PRECAUTIONS PROBE Non-invasive probes are for transcutaneous use only Probe transducer tips are thin and delicate. Be careful not to drop or hit the probe tip. After use, protect the transducer with the probe cap. ULTRASOUND GEL Use ultrasound gel. Use of other materials such as baby oil and cream may not produce correct Doppler sound, and may damage the probe.
  • Page 3: Table Of Contents

    TABLE OF CONTENTS ES-100VX MiniDoppler ® INTRODUCTION CLINICAL APPLICATIONS ................2 CONTROLS ....................…3-4 REPLACING THE BATTERY ................. …5 TURNING THE UNIT ON & OFF ...............5 OPERATION ....................6-7 PROBE SELECTION ..................8 PRINCIPLES .......................9 BLOCK DIAGRAM ....................10 SPECIFICATIONS .....................11 CLEANING ......................12 WARRANTY ......................12 SAFETY STANDARDS ................
  • Page 4: Introduction

    Thank you for choosing the ES-100VX MINIDOPPLER … ® The ES-100VX MiniDoppler has four non-invasive interchangeable probe frequencies ® of 2.25, 5, 8, and 10 MHz for detection of arterial and venous blood flow in the lower extremities. The 2.25 MHz focused probe is for fetal heart rate measurement. FEATURES •...
  • Page 5: Clinical Applications

    ES-100VX MiniDoppler ® CLINICAL APPLICATIONS The ES-100VX can be used for the following clinical applications: • Fetal heart sounds • Peripheral vascular procedures • Pedal pulse checks • Blood pressure segmental studies • Venous compression studies...
  • Page 6: Controls

    ES-100VX MiniDoppler ® CONTROLS Front Panel PROBE CONNECTOR To connect the probe to the Doppler HEADSET CONNECTOR To connect a headset (not provided) VOLUME CONTROL To adjust the sound volume POWER INDICATOR Indicates power ON/OFF SPEAKER Outputs Doppler sound...
  • Page 7 ES-100VX MiniDoppler ® CONTROLS Rear Panel PROBE HOLDER For probe placement when not in use STRAP HOLES To connect the carry strap BATTERY COVER See “Replacing the battery” on page 5 PROBE Choose from 2.25, 5, 8 & 10 MHz frequencies (8 MHz vascular & 2.25 MHz fetal are most common) PROBE BUTTON Activates the ES-100VX...
  • Page 8: Replacing The Battery

    ES-100VX MiniDoppler ® REPLACING THE BATTERIES REPLACING THE BATTERY Press down on the battery cover and slide in the direction of the arrow, as pictured on the right. Place a 9-volt alkaline battery in the unit, making sure that the positive and negative electrodes correspond to the + and –...
  • Page 9: Operation

    ES-100VX MiniDoppler ® OPERATION Connect the probe to the ES-100VX with the arrow on the probe connector pointing up (12 o’clock position). Place ultrasonic gel on the probe tip or the patients skin. Make sure there is enough gel to cover the tip of the probe.
  • Page 10 ES-100VX MiniDoppler ® OPERATION (cont.) Figure A Place the probe on the skin and move slowly to locate the point where maximum Doppler sounds are heard (see below for your probe type). [Pencil Style Probe] If using the pencil style probe, hold the probe softly against the measurement area at an angle of approximately 45 to 60 degrees to the skin surface (see...
  • Page 11: Probe Selection

    ES-100VX MiniDoppler ® PROBE SELECTION The frequency of diagnostic ultrasound is inversely proportional to depth of penetration. The ES-100VX has 4 interchangeable non-invasive probes with different frequencies. Probe selection depends on the application. BT2M20S8C (2.25 MHz) : Fetal heart beat & sounds (GTIN# 00894912002326) BT5M05S8C (5 MHz) Deep peripheral blood flow...
  • Page 12: Principles

    ES-100VX MiniDoppler ® PRINCIPLES The ES-100VX MiniDoppler is designed to receive blood flow velocity information ® through the use of ultrasound. A specific frequency is transmitted from the probe to the patient. The transceiver amplifies a high frequency oscillation output for transmission to the transducer.
  • Page 13: Block Diagram

    ES-100VX MiniDoppler ® BLOCK DIAGRAM...
  • Page 14: Specifications

    ES-100VX MiniDoppler ® SPECIFICATIONS Probes: Model Freq. Multiple frequencies BT2M20S8C 2.25 MHz BT5M05S8C 5 MHz BT8M05S8C 8 MHz BT10M5S8C 10 MHz BF8M15S8A 8 MHz (flat) Battery: DC 9-volt, alkaline battery Battery life: Approximately 3 hours (alkaline) Automatic shut-off: No signal: 3 min. Probe button: Power ON/OFF Speaker output:...
  • Page 15: Cleaning

    ES-100VX MiniDoppler ® CLEANING DOPPLER BOXES AND NON-INVASIVE PROBES The Doppler box and probe can be wiped down using warm water, enzymatic cleaner, or alcohol with a damp soft cloth after use. If an enzymatic cleaner is used, wipe down again using warm water or alcohol with a damp soft cloth.
  • Page 16: Safety Standards

    ES-100VX MiniDoppler ® SAFETY STANDARDS The ES-100VX conforms to the following standards: Guidance and manufacturer’s declaration - electromagnetic emissions and immunity Guidance and Manufacturer’s Declarations Electromagnetic Emissions The ES-100VX is intended for use in the electromagnetic environment specified below. The user of the ES-100VX should assure that it is used in such an environment.
  • Page 17 ES-100VX MiniDoppler ® Guidance and Manufacturer’s Declarations (cont.) Electromagnetic Immunity The ES-100VX is intended for use in the electromagnetic environment specified below. The user of the ES-100VX should assure that it is used in such an environment. Immunity test IEC60601 test level Compliance level Electromagnetic environment - guidance...
  • Page 18 ES-100VX MiniDoppler ® Guidance and Manufacturer’s Declarations (cont.) Electromagnetic Immunity (cont.) The ES-100VX is intended for use in the electromagnetic environment specified below. The user of the ES-100VX should assure that it is used in such an environment. Immunity test IEC60601 test level Compliance level Electromagnetic environment...
  • Page 19 Koven Technology, Inc. 477 N. Lindbergh Blvd., Suite 220 St. Louis, MO 63141 Tel: 800-521-8342 • Fax: 314-542-6020 E-mail: info@koven.com www.koven.com GLN: 0894912002005 OM-1155 Copyright © Koven Technology, Inc., St. Louis, MO...

Table of Contents

Save PDF