Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for NuAge Beauty OxyOasis
Summary of Contents for NuAge Beauty OxyOasis
- Page 1 Page | 1 ©2014 NuAge Beauty, Inc. All Rights Reserved. 206485 NA.OO.10.1.0814.7.U...
- Page 2 9220 James Avenue South, Minneapolis, MN 55431 Dear OxyOasis Owner: Congratulations! We welcome you as a new owner of an OxyOasis System. Enclosed you’ll find your OxyOasis Owner’s Manual. In it, you’ll find set-up and operating instructions, facial protocols as well as service and troubleshooting tips. If you have questions, please feel free to contact your Sales Representative or our Customer Service Department.
-
Page 3: Table Of Contents
Assembling and Connecting the Micro Mist Air Spray Brush _______ Section 5 Operation Operating Your OxyOasis Operating your Micro Mist Air Spray Brush _____________________ Right/Wrong Ways to Use your OxyOasis System ________________ 14 Section 6 OxyOasis Protocols, featuring Oxygen Botanicals™ “Mini Blast” “Super Blast”... -
Page 4: Section 1 Introduction
1.1 Purpose of the Manual This manual explains how to correctly install, operate, and get the best performance from your OxyOasis System. It will ensure you are utilizing the OxyOasis properly and effectively. It also includes troubleshooting guidelines for mechanical and electrical difficulties. - Page 5 OxyOasis System. No attempt has been made to designate as trademarks or service marks all words or terms in which proprietary rights might exist.
-
Page 6: Section 2 Safety
Oxygen is not a flammable gas, but it accelerates the combustion of materials. To avoid all risks of fire, the OxyOasis should be kept away from all flames, incandescent sources and sources of heat (cigarettes), as well as any combustible products such as oil, grease, solvents, aerosols, etc. -
Page 7: Warnings
Unplug the power cord from the AC wall outlet before cleaning. Do not use if the power cord is damaged. Note: The distributor and the manufacturer accept no responsibility for damages to person or property resulting from improper use of the OxyOasis System. Page | 7... -
Page 8: Section 3 Product Introduction
This is not a medical device. OxyOasis is a device that filters ambient air to provide the user with an uninterrupted flow of enriched oxygen. A compressor pulls in air and raises the air pressure in order to prepare the oxygen and nitrogen for filtration. -
Page 9: Section 4 Installation
SECTION 4: INSTALLATION 4.1 Operational Components 1. Power Switch 2. Oxygen Outlet 3. Flow Meter with Control Knob 4. Air Filters 5. Place for Humidifier bottle (not to use with the air spray brush) 6. LED Display 6.a Time Counting System (CU= current use session time/total use) 6.b Power Disconnection 6.c Abnormal Voltage... -
Page 10: Starting Up/Testing
2. Connect the other end of the tubing to dispensing method (air spray brush, capsule, etc.). The tube between the customer and the OxyOasis should be less than 5 feet long, in order to ensure that the oxygen flow rate remains satisfactory. -
Page 11: Assembling And Connecting The Micro Mist Air Spray Brush
4.4 Assembling and Connecting the Micro Mist Air Spray Brush Attention: never use your humidifier bottle with the use of the air spray brush 1. Attach tail piece to the base on the bottom of the spray brush. Serum/fluid cup Oxygen &... -
Page 12: Section 5 Operation
SECTION 5: OPERATION 5.1 Operating your OxyOasis Follow the steps outlined in section 4.2 to test and connect the oxygen administration tubing. 1. After initializing the oxygen concentrator, press the power switch to turn ON the concentrator. For best results, turn on the device 5 minutes before you intend to use it. - Page 13 Holding Your Air Spray Brush To hold the micro mist air spray brush effectively and ergonomically please use the following steps: • Firstly hold your hand flat with your thumb facing upwards. • Place the spray brush with the nozzle sitting on your middle finger and the end of the spray brush cradled in the groove of your thumb.
-
Page 14: Right/Wrong Ways To Use Your Oxyoasis System
2. When spraying smaller areas such as the eye, nose or upper lip you must be 1 cm (about ½ inch) away from the surface of the skin. 5.3 Right/Wrong Ways to Use your OxyOasis System Use of OxyOasis with Micro Mist Air Spray Brush WRONG Page | 14... -
Page 15: Mini Blast
Prepare the micro mist air spray brush: fill up the fluid cup half-way with water based products like activators or serums. Turn on your OxyOasis and adjust flow meter to at least 3.5 LPM Start by pulling the trigger halfway to release the gentle, adjustable flow of oxygen-enriched... -
Page 16: Super Blast
2. Cleanse skin with a cleanser and rinse with a warm towel 3. Exfoliate skin 4. Turn on your OxyOasis and adjust flow meter to at least 3.5 LPM 5. Use the micro mist air brush without product in the fluid cup;... -
Page 17: Secret Glow
2. Cleanse skin with small amount of cleanser and rinse with a warm towel 3. Exfoliate 4. Turn on your OxyOasis and adjust flow meter to at least 3.5 LPM 5. Take the micro mist air brush and use it without product in the fluid cup: work close to the skin in quick, back and forth motions 6. -
Page 18: Section 7 Troubleshooting
SECTION 7: TROUBLESHOOTING 7.1 Minor Troubleshooting Guide Problem Probable Cause Solution The power cord Connect power cord to wall outlet. Unit does not operate is disconnected. Check power source, fuses, No power at breakers, switches, etc. outlet. -
Page 19: Section 8 Maintenance
SECTION 8: MAINTENANCE 8.1 Cleaning Air Filters The air filters located on the right side and underneath the cabinet should be cleaned at least once a week to keep your concentrator running properly. 1. Turn off your concentrator and remove the foam filter inserts from the right side and underneath the cabinet. - Page 20 Micro mist air spray brush cleaning instructions Using a small bristle brush and the isopropyl alcohol, clean any residue from the color cup. Once this is done you should back flush the airbrush by filling the product cup with isopropyl alcohol, pull the trigger with your finger covering the air tip, as pictured below in pic 1.
-
Page 21: Section 9 Specification Information
SECTION 9: SPECIFICATION INFORMATION 9.1 General 0.5 – 5 LPM Oxygen Outlet Flow Maximum Outlet Flow 5 LPM Oxygen Concentration 85% +/- 5% Electrical Rating 110V-220V, 50 Hz-60 Hz Power Consumption 300 Watts 5 ºC – 40 ºC Operating Environment ≤... -
Page 22: Product Warranty
Sybaritic, Inc. Product Warranty Oxy Oasis Facial System Product Warranty Term This One Year Product Warranty will expire 12 months from the Original Purchase Invoice Date. General Terms and Conditions Sybaritic, Inc. (hereinafter “SYB”) agrees to provide warranty service according to the terms and conditions set forth in this document. - Page 23 USE OF SUB-CONTRACTORS: Service provided under this Product Warranty may at SYB’s option, be performed by either SYB or its authorized Technical Representatives or Sub-Contractors at the direction of SYB. PARTS REPLACEMENT: Repair materials and parts used to perform service pursuant to this Product Warranty will be replaced only as deemed necessary by SYB.
Need help?
Do you have a question about the OxyOasis and is the answer not in the manual?
Questions and answers