Advertisement
lifetime limited
warranty
Your Drive brand product is warranted to be free
of defects in materials and workmanship for the
lifetime of the original consumer purchaser.
This device was built to exacting standards and
carefully inspected prior to shipment. This Lifetime
Limited Warranty is an expression of our confi-
dence in the materials and workmanship of our
products and our assurance to the consumer of
years of dependable service.
In the event of a defect covered by this
warranty, we will, at our option, repair or replace
the device.
This warranty does not cover device failure
due to owner misuse or negligence, or normal
wear and tear. The warranty does not extend to
non-durable
components,
accessories, casters, and grips, which are subject
to normal wear and need periodic replacement.
If you have a question about your Drive device or
this warranty, please contact an authorized Drive
dealer.
© 2006 Medical Depot, Inc. All rights reserved.
Drive is a trademark of Medical Depot, Inc.
Port Washington N.Y. 11050 USA Made in China
such
as
rubber
economy i.v. pole
item # 13033
www.drivemedical.com
Advertisement
Table of Contents
Related Manuals for Drive 13033
Summary of Contents for Drive 13033
- Page 1 If you have a question about your Drive device or this warranty, please contact an authorized Drive dealer. www.drivemedical.com © 2006 Medical Depot, Inc. All rights reserved.
- Page 2 assembly instructions Overlay top leg (A) with pre-assembled pin (F) over corresponding holes in the middle of the bottom leg (B) Hammer the pin (F) into bottom leg and making sure that it’s flush with the top leg. Place lock washer (D) onto bolt (E) and install from the bottom side of the base into bottom of post (C).
Need help?
Do you have a question about the 13033 and is the answer not in the manual?
Questions and answers
The lock collar doesn't tighten.
To fix the lock collar on Drive part number 13033 that doesn't tighten, follow these steps:
1. Check for Obstructions – Ensure there is no debris or damage preventing the collar from turning properly.
2. Hold the Top Post – Use one hand to stabilize the top post while adjusting the lock collar.
3. Turn the Lock Collar – Rotate the screw-type lock collar (H) to tighten it. If it does not hold properly, try turning it further.
4. Apply More Force – If the collar is loose, tighten it more firmly to secure heavier hook loads.
5. Inspect for Damage – If the collar is stripped or worn, it may need replacement.
If the issue persists, contact an authorized Drive dealer for further assistance.
This answer is automatically generated