Related Manuals for Amazon Allison
Summary of Contents for Amazon Allison
- Page 1 Kindle Heater Allison Bella Commercial Patio Heater Instructions Your guide to executing mood and atmosphere in ways you’ve never imagined. Reinventing the patio heater...
- Page 2 IMPORTANT! READ PRIOR TO ASSEMBLY Never operate indoors! This heater produces carbon dioxide gas and if operated indoors can cause injury or death! • Consult and adhere to the separate instructions provided by the manufacturers of the patio heater and/or the natural gas line before use for proper installation, ignition, and operation.
- Page 3 Attach the 3 large C-brackets to the weighted base using a bolt, secondary nut and lock washer. Tighten these bolts firmly. FOR ALLISON MODEL Attach the socket plate to the top of the C-brackets. Then connect the support bracket using the acorn nuts, bolts and lock washers.
- Page 4 Firmly attach the end of the gas pipe that has the teflon tape to the heater head. Slide the black pole over the gas pipe and secure with the 4 smaller screws. Attach the reflector and shade bracket to the top of the heater head.
- Page 5 Place the heater head upside down. Slide the trim ring (or optional cocktail table) and Kindle neck over the pole as far as possible, until resting snuggly against the base of the heater head. Align the Kindle logo with the control knob.
- Page 6 Attach optional light ring to the base of the Kindle neck using the 3 small self tapping screws. Be careful not to over-tighten these screws as they may crack the light ring. Place the Kindle base cover over the weighted base, then slide the heater assembly into the socket post.
- Page 7 With the help of a friend, lean the Kindle Heater to one side and gently place the shade on top of the heater so it rests upon the shade bracket. Please take care not to damage the Firewall. Lift the Kindle base cover, rest it on the support bracket and attach the regulator to the gas pipe.
- Page 8 Attach the regulator to the propane tank. Open the valve on the propane tank. To ignite the Kindle Heater: Turn the control knob to “PILOT”. Then push the knob in and hold. While holding down the pilot knob, press and hold the red ignitor button until the pilot flame ignites.* Continue to hold the pilot knob for...
- Page 9 45 in 114 cm 100 in 254 cm 29 in 29 in 74 cm 73 cm Allison 23 in 23 in 58 cm 58 cm Pleated Shade Box 1: 50”x46”x30” kindle weight: 150 lb kindle weight: 150 lb Box 1: 45”x45”x43”...
- Page 10 45 in 45 in 101 cm 114 cm 100 in 254 cm 20 in 51 cm Bella A l l i s o n Smooth Shade 24 in 24 in Smooth Shade 58 cm 61 cm Box 1: 50” x 46” x 30” kindle weight: 150 lb Box 1: 50”x46”x30”...
- Page 11 o Cleaning & Maintenance: Body & Shade (Outside) – Kindle body and lampshade are both made of composite resins that are inherently scratch, chemical, UV and fade resistant. All surfaces—except for Firewall —should be regularly washed clean with soapy water using a rag or sponge (avoid abrasive pads) and towel dried.
- Page 12 www.kindleliving.com 3 1 0 . 4 0 0 . 3 0 2 4 2048 Armacost Ave. Los Angeles, CA 90025 Designed and Constructed in Southern California © 2013 Kindle Living 2016 Patented www.KindleLiving.com/patents V.11.15...
Need help?
Do you have a question about the Allison and is the answer not in the manual?
Questions and answers