Install The Thermostat; Wiring Diagram - Saswell SAS810FHL-7 Manual

ATTACH THERMOSTAT BASE TO WALL
1
3
1.
Remove the packing material from the thermostat. Gently pull the control panel straight off the base. Forcing or
prying on the thermostat will cause damage to the unit. See figure 3-1 & 3-2.
2. The floor sensor cable must be installed to terminal block in heating type F or RF,
3. Connect wires beneath terminal screws on power base using appropriate wiring schematic.
4. Push power base into conduit box. See figure 3-3.
5. Using two mounting screws mount the power base to the wall. Place a level against bottom of base, adjust until
level, and then tighten screws. (Leveling is for appearance only and will not affect thermostat operation.)
6. Replace control panel on the power base by snapping it in place. See figure 3-4.
Attention :
N: Neutral Wire ; L: Live Wire.
Item 1-2: Connected with power.
Item 6-7: Connected with sensor (NTC100K).

INSTALL THE THERMOSTAT

2
4
screw for mounting
thermostat to wall
Figure 3

WIRING DIAGRAM

Item 3-4: Connected with heating load.
B a s e
p u ll t h e c o n t r o l p a n e l
s t r a i g h t o f f t h e b a s e
Fix the cover on the base
P a n e l
Figure 4
3