Spring wfp Link Quick Start

Step 1. Fob Overview
Before you can use your fob it must be paired with its
controller. Please see step 3 for details.
Start/Stop
Press once to stop
pump. Whole LED
segment lights to
indicate STP.
Controller will
show 'StP'.
Press once to
start pump.
One LED lights
to indicate pump
has started.
Auto-Calibrate
Press and hold
until whole LED
segment lights.
One LED lights to indicate
calibration has finished.
Specification
Supply Voltage*
Enclosure Material
Water Resistance
Dimensions
Working Temperature
* Charge only with micro USB phone chargers or similar micro USB adaptors.
DISCLAIMER
THE MANUFACTURER RESERVES THE RIGHT TO MAKE CHANGES TO ANY PRODUCT HEREIN TO IMPROVE
RELIABILITY, FUNCTION OR DESIGN. THE MANUFACTURER DOES NOT ASSUME ANY LIABILITY ARISING OUT OF THE
APPLICATION OR USE OF ANY PRODUCT OR CIRCUIT DESCRIBED HEREIN.
Pump Decrease
Each press will
reduce pump flow
by 10.
LED segments
indicate this.
Pump Increase
Each press will
increase pump flow
by 10.
LED segments
indicate this.
Value
5 VDC
ABS
IP61
75 x 16mm
0 to 40 Deg C
wfp Link - Quick Start
Step 2. Fob Charging
Your fob will indicate when it needs charging by lighting
two LEDs.
Charging
LED
DO NOT IMMERSE FOB IN WATERr. Doing
!
so will result in damage to the unit.
DO NOT LEAVE IN DIRECT SUNLIGHT. Doing
so will result in damage to the unit.
v11
To Charge
Plug in micro USB
phone charger or similar
to the charging connector.
Charging LED is red
when charging.
Charging LED is green
when charged.