Weeders Digest AquaThruster 360 Assembly & Installation

AquaThruster 360
Assembly & Installation
To get your AquaThruster system up and running, you need 3 items:
Motor, Mounting Bracket and AquaThruster 360
Your system will typically be provided in 2 boxes, one with the motor (and
mounting kit already attached). The second with the AquaThruster 360 and
Mounting Bracket

Assemble as follows:

3. Slide bottom plate back onto the stationary shaft.
Lay unit on a flat surface to insure that the
stationary and rotating shafts are parallel. Set
screws on the bottom plate MUST be Securely
tightened!
NOTE: The mount MUST align the rotating shaft with
the center line of the prop shaft as shown on right.
1. Remove bottom plate of 360 from
stationary shaft by loosening set screws
using supplied allen wrench.
2. Slide the Mounting Bracket onto stationary
shaft so the system can be securely mounted later
in the assembly.
NOTE: Mounting bracket
options include Dock Plate,
Portable Post Mount or Truss
Mount.
4. Attach the motor to Swivel plate
using 2) 1/2" bolts, washers and nuts supplied. The prop should
be pointed the same direction as the green indicator pin.
CAUTION: The motor MUST be positioned at
least one hole up from level in order to keep
from disturbing the bottom surface as shown
on left.
022018AT
Page 1 of 2