Toro 31512 Installation Instructions

Backup Alarm Kit
Model No. 31512
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
The Backup Alarm Kit can be installed on the following
machines:
•
Groundsmaster 4000 Series
•
Groundsmaster 4100 Series
•
Groundsmaster 5900 Series
Note:
This kit is not for use on the Outcross 9060.
© 2019—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Description
No parts required
Backup alarm
Hex-head screw (1/4 x 3/4 inch)
Flange nut (1/4 inch)
Wire harness
Tie clip
Clamp
Cable tie
No parts required
No parts required
Register at www.Toro.com.
Qty.
–
Prepare the machine.
1
2
2
1 Install the backup alarm.
2
1
2
–
Enable the alarm in the InfoCenter.
–
Check the backup alarm.
1
Preparing the Machine
No Parts Required
Procedure
1. Park the machine on a level surface.
2. Lower the cutting units.
3. Engage the parking brake.
4. Shut off the engine and remove the key.
5. Disconnect the negative battery cable from the
battery.
6. Disconnect the positive battery cable from the
battery.
Original Instructions (EN) All Rights Reserved *3435-312* A
Printed in the USA
Form No. 3435-312 Rev A
Installation Instructions
Use