Electrical Connections; Platform Installation - Challenger Lifts SX14 Installation, Operation & Maintenance Manual

Layout the service bay according to the
1)
architect's plans or owners instructions (see
Fig. 1) . Failure to install in this orientation
can result in personal and property damage.
Be certain that the proper conditions exist,
see page 15.
The control console can be located on the
2)
driver side or passenger side of the lift at a
maximum standard distance as shown in
Fig. 1 . IMPORTANT: Console should be
positioned so the lift operator has clear
view of the vehicle and bay area during
lifting/lowering. Relocating the control
console from the driver side to the
passenger side will require moving the
green hose blocks at the base of the unit to
direct the hoses/lines to the opposite side.
Relocating the control console further away
3)
than the standard distance will require the
installer to provide suitable hydraulic hoses
and air lines. Additional hose covers will also
be needed if installing lift in surface mount
configuration. Hydraulic hoses should be
1/4" minimum ID with a minimum working
pressure of 4,200 psi and a minimum burst
pressure of 16,800 psi with #6 JIC fittings (1)
Male x (1) Female Swivel. The air lines for
the lift have outside diameters of 4mm,
6mm, and 10mm and should have a
minimum working pressure of 120 psi.
Maximum dimension "E" from Fig. 1 is 20
feet IF hose and air line extensions are
used . Electrical wiring from lift should not be
modified/extended for safety reasons.
F M P R
LUSH OUNT IT
PRIOR TO POURING CONCRETE, installer
4)
will need to ensure pit frame, piping, and
forms conform to details shown in Fig. 3 . Pit
frame and temporary pit forms are NOT
PROVIDED and will be the responsibility of
the installer. Total pipe chase length should
not exceed 13' for standard install or 20' if
line extensions will be supplied by installer.
P I
LATFORM NSTALLATION
Place packaged lift onto 4x4 pieces of
5)
lumber and remove steel end brackets.
Remove any accessories
6)
packaged with the platform assemblies.
DO NOT cut the bands securing the bases
7)
of each assembly to the platform. These
keep the scissors in a collapsed position.
With the top platform assembly ready to be
8)
placed into position, place a lifting strap(s)
under the assembly
manuever into position.
EQUIREMENTS
that are
and carefully
Repeat for other platform assembly and
9)
remove any remaining banding/packaging.
Remove all electrical/hydraulic/air lines
10)
from under platforms and route to the
control console.
E C
LECTRICAL ONNECTIONS
Use an Allen wrench to loosen the (2)
11)
screws on the sides of the control cover of
the console.
Ensure Main Switch located on control
12)
cover is turned to the "OFF" position and
open the cover.
OFF
Fig. 4 – Main Switch
Route electrical
13)
assemblies thru opening in the bottom rear
of the console and thru the opening in the
sidewall of
compartment.
Using the numbering on each of the
14)
supplied wires, connect each to the
corresponding terminal in the console as
shown in Fig. 5 .
screwdriver will be needed for this step.
Fig. 5 – Wiring Connections
- Each lift shall have a dedicated circuit
with a double-pole breaker or time delay
fuse sized according to Fig. 13.
-Wiring must comply with all local
electrical codes.
17
lines from platform
the upper electrical
A small flat head