Safety Instructions - Analytik Jena multi N/C 2100 Operating Manual

Safety instructions

2 Safety instructions
IMPORTANT
This user manual is only valid in conjunction with the following documents:
User manual for multi NC 2100/2100S

Software manual of the control and analysis software multiWin

Observe in particular the notes in the chapters "Safety notes" of these operating manuals.
The notes included there apply correspondingly also to the Double Furnace Solids Module
without any limitations.
Special dangers implied in the Double Furnace Solids Module will be indicated separately in
the single chapters.
Observe all safety notes listed in this operating manual and observe all messages and notes
displayed by the control and analysis software multiWin on the monitor.
Please observe the following notes when connecting and operating the Double Furnace Sol-
ids Module:
CAUTION
There is a risk of burning on the combustion furnace! Only remove the combustion tube
when the device is cold or allow the device to cool down sufficiently!
Before switching off set the furnace temperature in multiWin to 20 °C and exit multiWin.
Otherwise there is a risk of burns when checking the system for leaks after installation!
2 Edition 05/2011 Double Furnace Solids Module