Fitting The Panel To The Mounting Surface - Honeywell ESSER IQ8Control C Installation Instruction

Fire Alarm Control Panel IQ8Control C / M
5.3

Fitting the panel to the mounting surface

Fig. 15: Fitting the panel to the mounting surface
Take note of any cables that are routed over the top of the surface/plaster (TS) or behind the
surface/plaster (US) before attaching the housing!
24

Chose the place for mounting the panel as
specified in the project documentation.

Observe the installation environment
specifications.

Take note of the position of the cables and
corresponding cable entry points

Hold the rear housing panel horizontally
(align using a spirit level) against the
mounting surface and mark the four
mounting holes.
4 x
FB 798951.10.GB0 / 04.15