Checking Before The Setup; Switching The Connection Method To Wireless Lan; Checking The Router - Canon imageClass MF4890dw Settings Manual

Checking Before the Setup

Internet
Is the computer connected to the router (or the access
point) correctly by a LAN cable or wireless LAN?
For more information, see the instruction manual for the
network device you are using, or contact the networking
device manufacturer .
Has the network settings on the computer been
completed?
If the computer is not properly configured, you may not use
the wireless LAN connection even after completing the
following settings .
NOTE
• You cannot connect both the wired LAN and wireless
LAN at the same time . In addition, the machine is set
to the "Wired LAN" by default .
• When you connect to a network environment that
is not security protected, your personal information
could be disclosed to third parties . Please use
caution .
• If you connect through a LAN in the office, contact
your network administrator .
• When proceeding from "Specifying the Initial
Settings" in the Starter Guide:
Proceed to "Checking the Router" on the right side of this
page .
Switching the Connection Method to
Wireless LAN
1
Press [ ] (Menu) .
2
Select <Network Settings>, and then press [OK] .
En
3
Select <Select Wired/Wireless LAN>, and then
press [OK] .
4
Wireless LAN Router
4
Select <Wireless LAN>, and then press [OK] .
Select LAN
Wired LAN
Wireless LAN
5
Restart the machine for the settings to take effect .
10 Seconds
OFF

Checking the Router

Select the connection method to the wireless LAN . Select
from the following two methods depending on the router or
the access point that you are using .
There is a button .
This machine supports WPS
(Wi-Fi Protected Setup) .
You can easily setup if your
router or access point has a
button, and if the mark is on
the router .
If you are not sure whetheror not your router supports WPS,
please see the manual included in the product, or contact the
product manufacturer .
There is no button .
If there is no button on your
router/access point, you may
manually select SSID and
complete the settings . In this
case, you need to remember
SSID and network key of your
router/access point .
See "Checking SSID or
Network Key for a Wireless LAN Router/Access Point" (P .7)
to learn how to find out your SSID and network key .
To set up with WPS PIN code method, or setup
manually:
e-Manual "Setting the Machine Using WPS (PIN Code
Mode)"
e-Manual "Setting by Manually Entering SSID"
• When proceeding from "Specifying the Initial
Settings" in the Starter Guide:
Proceed to step 3 of "Setting Wireless LAN" (P .5) .
ON