AFINIA LABEL L801 Replacing

Replacing microfiber roller

Replacing Microfiber Roller:

Why do we do this?

Throughout the life expectancy of the printhead a lot of media comes in contact with printhead. This

media carries debris and other artifacts across the printhead which can get stuck and cause poor print

quality with time. The microfiber roller wipes the printhead down and absorbs residual ink left over from

past print jobs. Over time this microfiber roller becomes warped and needs to be changed.

•

Replace microfiber roller

•

Nitrile Gloves

•

Screw Driver - Eye Glass Repair Kit

•

Piece of cardboard / Lint free cloth

Eject the service tray from the printer:

In order to access the setting to eject the service station – you will need to log on through the touch

panel. Enter "Configuration Mode" by selecting the gear found in the lower left hand corner of the touch

panel. Select "Setup", while in "Setup" scroll down to "Security" and select "Level 2". The operator will

be prompted to enter a password, the password is "123". At this point in time after hitting enter you can

scroll through the "Configuration" menu to option 4 labeled as "Service Station" . Before ejecting the

service station lift up on the hood of the printer as well as the clamshell.

For additional support call the Vivid Data Group Support Team at 855-848-4332 and select Option 2

Installment 1796

Table of Contents

Do you have a question about the L801 and is the answer not in the manual?

Page 1 Installment 1796 Replacing Microfiber Roller: Why do we do this? Throughout the life expectancy of the printhead a lot of media comes in contact with printhead. This media carries debris and other artifacts across the printhead which can get stuck and cause poor print quality with time.
Page 2 Installment 1796 Slide the Service Station out of the Service Station port. NOTE: Do not pull Station all the way out until you disconnect the Ribbon Cable. Slide the Latch open on the Service Station Circuit Board to release the Ribbon Cable. Remove the Service Station. Figure 1.
Page 3 Installment 1796 After the service station has been disconnected from the ribbon cable and removed from the print engine place the service station down on a piece of cardboard. The service station holds all of the discarded ink from the printhead and funnels that ink down on to the ink wastepad. Remove each of the following four compartments from the service tray: •...
Page 4 Installment 1796 With these components accessible – isolate your Micro-Fiber Roller. Utilizing a small Phillip’s head screw driver. Loosen, but do not remove the screws, holding the plastic locking clips on the left and right side of the Micro-Fiber Roller in place. After loosening these screws enough, the plastic locking clips should release.