Page 1
Installation and operating instructions Installation and operating instructions JUDO PROFI-QC JUDO PROFI-QC Backwash protective filter DN 125 - 200 Backwash protective filter DN 125 - 200 Valid for: EU countries and Switzerland Valid for: EU countries and Switzerland Language: English...
Page 2
D-71351 Winnenden uct. You have purchased a state-of-the- art device. It has been carefully checked Email: info@judo.eu • judo.eu prior to delivery. Nevertheless, if diffi- culties occur, please contact the closest customer service (see chapter Customer Office address: service).
30 °C! In higher temperatures The water pressure must not exceed or direct sunlight, material damage may 10 bar input pressure. The device occur up to and including breakage of must not be installed if the mains device parts. JUDO JPF-QC 1701803 • 2019/11...
• Type label Do not use household cleaning agents • Cleaning information to clean the outside of the device, but only use clear water to avoid embrittle- ment of the plastic. 1701803 • 2019/11 JUDO JPF-QC...
The dirt particles remain on the sieve fabric of the sieve insert. The adhering residues are visible from outside through the transparent filter bowl. Subsequently the filtered water exits the device again via the connection flange. JUDO JPF-QC 1701803 • 2019/11...
Page 7
Setting ring for the next backwash date Filter hood Flange Waste water connection (ball valve with black handle; to be closed only in case of a failure) Discharge of sludge trap (ball valve with blue handle) 1701803 • 2019/11 JUDO JPF-QC...
30 °C! In higher temper- atures or direct sunlight, mater- ial damage may occur up to and including breakage of device parts. An adequately sized waste water connection (e.g. floor drain) in compliance with DIN 1986 must be provided. JUDO JPF-QC 1701803 • 2019/11...
The ball valves are secured with a seal- ing adhesive. The drain must be large enough so that all of the wastewater can be drained simulta- neously. 1701803 • 2019/11 JUDO JPF-QC...
2. Attention: Carry out a backwashing immediately so that the trapped air can escape (see chapter 4.1.2)! This pre- vents damage to the installation by water hammer pressure surges. After backwashing, the device is vented and ready for operation. JUDO JPF-QC 1701803 • 2019/11...
These can impair the the device is required at the latest every six functioning of the device, leading months. to leaks and, in the worse case The manufacturer requires a backwash- scenario, to bursting of the device. ing: 1701803 • 2019/11 JUDO JPF-QC...
• Inform the installer or the closest customer ser- becomes exposed to high vice point. clouded. temperatures or • If water escapes, close shut-off valves. Have the solvents. filter bowl replaced immediately. Hairline cracks on the filter bowl. Troubleshooting 1701803 • 2019/11 JUDO JPF-QC...
(see chapter 4.1). The DIN EN 13443-1 pre- scribes that the backwashing must take place every six months. JUDO however recommends to comply with the information in chapter 4.1.1 Backwashing interval. To ensure the process operates success-...
Technical data Technical data Backwash protective filter JUDO PROFI-QC DN 125 - 200 JPF-QC DN 125 - 200 The water to be filtered must comply with the European Drinking Water Directive. Information about: JPF-QC DN 125 JPF-QC DN 150 JPF-QC DN 200...
JPF-QC DN 125 JPF-QC DN 150 JPF-QC DN 200 ¾" ¾" ¾" A Installation length B Unit depth C Height above the pipe middle D Height below the pipe middle G Nominal width waste water JUDO JPF-QC 1701803 • 2019/11...
Packaging waste is to be sent to the local recycling system. To protect environment, old appliances must not be disposed of with household waste. Instead, use the local collection and return points, which are committed to free and environmentally sound disposal. 1701803 • 2019/11 JUDO JPF-QC...
Need help?
Do you have a question about the PROFI-QC Series and is the answer not in the manual?
Questions and answers