Advertisement
Quick Links
To configure multi torque driver for use with any one of the
available 12 torque settings: Insert the end of hex shank of the bit
holder into appropriately marked hex socket of the driver arm, for
example, 15 inch-lbs. (Fig.1); then secure bit holder to the arm by
mounting the hex bit holder knob onto the hex shank (Fig.2)
Fig.1 Fig.1
Fig.2
Example #1
Multi torque driver
is configured for
tightening torque
of 15 inch-lbs.
Multi Torque Driver
Model: MTD-1285-12FS-MG
Torque settings: 12,15,18,22,25,28,35,45,55,65,75,85 inch-lbs.
Torque settings calibration accuracy: +/- 4% of torque values.
Made in the U.S.A. - Patent Pending - All rights reserved
Borka Tools, div. of Borka Enterprises, LLC
29383 Breezewood, Farmington Hills, MI 48331
Phone: 248-798-7621 E-mail: info@borkatools.com
Example #2
Multi
driver
torque
is configured for
tightening torque
of 25 inch-lbs.
Example #3
Multi torque
driver
is configured for
tightening torque
of 65 inch-lbs.
Advertisement
Summary of Contents for Borka Tools MTD-1285-12FS-MG
- Page 1 (Fig.2) Torque settings calibration accuracy: +/- 4% of torque values. Made in the U.S.A. - Patent Pending - All rights reserved Borka Tools, div. of Borka Enterprises, LLC 29383 Breezewood, Farmington Hills, MI 48331 Phone: 248-798-7621 E-mail: info@borkatools.com...
- Page 2 To use the driver for the tightening of right hand fasteners: Engage the fastener you intend to tighten, support the driver by the bit holder knob with the palm of your hand (Fig.3), and then apply tightening force to the handle finger notch (Fig.4), until driver handle rotates to the side (Fig.5), indicating that the tightening torque is applied.
Need help?
Do you have a question about the MTD-1285-12FS-MG and is the answer not in the manual?
Questions and answers