Table of Contents
Advertisement
4. Insert the battery voltage sensor terminal block in the Batt Remote port. This is
polarity sensitive. (Optional, requires a separate purchase).
WARNING
If unscrewing the Battery Voltage Sensor terminal block, make sure to not mix the wires.
It is polarity sensitive and may cause damage to the controller if connected incorrectly.
After connecting the battery to the charge controller, the controller will turn on
automatically. Assuming normal operation, the charge controller will cycle through
different display. They are as follows:
EN
Operation
Parameter
PV Array Voltage
Charging Current
Generated Energy
Battery Voltage
Temperature
Display
0.0
V
PV
0.0
A
PV
0.0
kWh
PV
0.0
V
BALL
0.0
F
0
BALL
12
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the ADVENTURER and is the answer not in the manual?
Questions and answers
I'm unable to remove Adventurer surface mount base from flush face plate of the controller