GSK 980TC3 Series Manual page 201

X1
X1.0：chuck releasing control signal（DIQP）
X1.1：outside chuck clamping in-position/inside chuck releasing in-position（WQPJ）
X1.2：outside chuck releasing in-position/inside chuck clamping in-position（NQPJ）
2. Control parameter
K011
K11.0 = 1：use the chuck；
=0：do not use the chuck.
The following K11.1 definition negation (NOT):
K11.1 =1：outside chuck mode, WQPJ is a outside clamping signal and NQPJ is a outside
chuck releasing signal;
=0：inside chuck mode, NQPJ is a outside clamping signal and WQPJ is a outside
chuck releasing signal.
K11.2 =1：the chuck releasing has no check switch;
=0：the chuck releasing has a check switch.
K11.3 = 1：the chuck releasing switch is a normally closed type;
=0：the chuck releasing switch is a normally open type.
K11.4 = 1：after power on, the chuck automatically outputs the state at which is before
power-off;
=0：after power on, the chuck does not automatically output any states.
K11.5 = 1：the chuck releasing/clamping is not relevant with the chuck operation;
=0：forbid the spindle rotation when the chuck releases/clamps, and forbid the chuck
releasing/clamping when the spindle rotates.
T021
T022
3. Control logic
Signals in outside
chuck mode
Signals in inside
chuck mode
When the system is turned on, DOQPJ（outside chuck clamping/inside chuck releasing）and
DOQPS（outside chuck releasing/inside chuck clamping）remain the previous state when power of;
namely, DOQPJ and DOQPS have power failure memory function.
When the chuck control input （DIQP） is valid, the chuck clamping/ chuck releasing signal is valid,
i.e., when the chuck control input signal is valid, the output state changes.
DOQPJ, DOQPS output states remain unchanged when reset, emergency stop state.
Chapter 4 Machine Debugging
BIT5 BIT4
Chuck clamping in-position check time ms
Chuck releasing in-position check time ms
WQPJ （ X1.1 ） ： chuck clamping in-position signal
Chuck
clamping DOQPJ (Y2.0) ： chuck clamping output signal
NQPJ （ X1.2 ） ： chuck releasing in-position signal
Chuck
releasing DOQPS (Y2.1) ： chuck releasing output signal
NQPJ （ X1.2 ） ： chuck clamping in-position signal
Chuck
clamping DOQPS (Y2.1) ： chuck clamping output signal
WQPJ （ X1.1 ） ： chuck releasing in-position signal
Chuck
releasing DOQPJ (Y2.0) ： chuck releasing output signal
NQPF WQPJ
BIT3 BIT2 BIT1
DIQP
BIT0
189