Troubleshooting - ALDI Deco Style DS-FSS 500 User Manual

4. Protect the paint spray system when storing it (e.g. in the original packaging or in
a box) if you do not use it regularly or will not be using it over an extended period.

Troubleshooting

Problem Possible cause
No material • Nozzle plugged.
in the nozzle.
• Suction tube plugged.
• Adjusting screw for ma-
• Suction tube loose.
• Pressure does not build
Material • Nozzle loose.
drips out of
• Nozzle worn out.
the nozzle.
• Nozzle seal worn out.
• Build-up of material in
Spray not • Material viscosity too
fine enough.
• Adjusting screw for ma-
• Nozzle dirty.
• Air filter very dirty.
• Not enough pressure
Spray jet cuts • Material in the paint con-
out.
• Air filter very dirty.
Paint runs. • Too much material
terial flow control turned
too far to the left (–).
up in the paint container.
the air cap and nozzle.
great.
terial flow control turned
too far to the right (+).
built-up in the paint
container.
tainer almost out.
applied.
Solution
• Clean the nozzle.
• Clean the suction tube.
• Turn the adjusting screw for
material flow control to the right
(+).
• Insert the suction tube.
• Screw the paint container firmly
in place.
• Tighten the nozzle.
• Change the nozzle.
• Change the nozzle seal.
• Clean the air cap and nozzle.
• Thin the material.
• Turn the adjusting screw for
material flow control to the left
(–).
• Clean the nozzle.
• Clean or change the air filter.
• Screw the paint container firmly
in place.
• Top up material.
• Clean or change the air filter.
• Turn the adjusting screw for
material flow control to the left (–).
Troubleshooting
25