Related Manuals for WESTHILL BIKES VENTURE
Summary of Contents for WESTHILL BIKES VENTURE
- Page 1 Electric Bike User Manual RANGER / CLASSIC HAVE A QUESTION? NEED HELP? Contact us on Facebook for a quick reply. westhillbikes.com RANGER | CLASSIC...
-
Page 2: Warranty
WARRANTY Westhill bikes are covered by a limited 3-year warranty. Aside from general cycle maintenance, any work to the motor should be carried out by a Westhill technician or authorised dealer. 1. Warranty periods Spokes The statutory warranty valid at the time of... - Page 3 TABLE OF CONTENTS INCLUDED IN THE BOX..................SPECIFICATIONS ....................ASSEMBLY....................... SAFE RIDING ....................... CHARGING THE BATTERY..................HOW TO USE THE BIKE CONTROLS..............CARE AND MAINTENANCE.................. SAFETY WARNINGS....................MODIFICATIONS....................ADDITIONAL OPERATION CAUTIONS............... THIS MANUAL SHOULD BE CONSIDERED A PERMANENT PART OF THE ELECTRIC BICYCLE AND SHOULD REMAIN IF IT IS RESOLD.
- Page 4 Display Seat Rear Wheel Rear Brake Motor fb.com/westhillbikes | westhillbikes.com...
-
Page 5: Specifications
SPECIFICATIONS MODEL VENTURE RANGER CLASSIC LINK Bike Wheel Size 27.5” 700c 26” 20” Frame Size 18” / 46 cm 19” / 48 cm 16.5” / 42 cm 13” / 33 cm Max Rider Weight 120kg 120kg 120kg 120kg Max Speed 25km/h 15.5mph... - Page 6 and stem, calipers, attach 6-10 the pedals and insert the seat post. whilst your bike. bike, call our team bike but assembly will still be the same. ATTACHING THE STEM AND HANDLEBAR 1. Place the stem onto the steerer tube, push down until it is flush against the spacer and fork clamp.
- Page 7 FRONT DISC BRAKE CALIPER Please check that the bolts are tightened correctly on the brake calliper shown below. Please be careful not to overtighten the bolts. Loosen the pin through the middle of the wheel to allow you to place the fork onto it.
- Page 8 Tighten the nut and hold the lever in an upright position as shown in the photo below. Once tight push the lever in to secure the wheel. TO CHECK Make sure the quick release clamping lever is secure. Make sure the brake is hooked onto the disc and working properly. Check your tyre pressure –...
- Page 9 There are 2 pedals. Please look inside of each pedal to identify which is labeled R (right) and L (left). To connect the pedals to the bike, place L pedal into the left crank arm and R pedal into the right crank arm (left and right directions are as though you are sitting on the bike).
-
Page 10: Attaching The Seat
ATTACHING THE SEAT • Slide the saddle post into the seat tube. • Align the seat with the frame to make sure it is straight. • The height of the seat should not be pulled higher than the safety line marks on the seat post. •... -
Page 11: Safe Riding
SAFE RIDING suffient charge Do not ride the bike through deep water. removable -ion the battery. The charging port is located on the side of the battery shown in the photo on p.12. battery charged and remove once completed. fb.com/westhillbikes | westhillbikes.com... -
Page 12: Charging Port
CHARGING PORT Do not turn on the bike while it is charging. charging port. In the unlikely event , step away from the battery and contact Westhill Bikes for further assistance. fb.com/westhillbikes | westhillbikes.com... -
Page 13: Functions And Display
KT-LCD7 E-BIKE DISPLAY USER MANUAL Dear customer, thank you for choosing your new Westhill Electric Bike. Please read this manual before using the KT-LCD7 display. The manual will guide you to use the display correctly and enjoy your e-bike to the fullest. FUNCTIONS AND DISPLAY KM/H UP button... - Page 14 FUNCTIONS AND DISPLAY 1. ON/OFF Hold button to turn the power ON, and hold button for a second time to turn the power OFF. When the motor stops driving and when the E-bike is not used for 5 consecutive minutes, it will automatically shut down and turn off the motor power supply.
-
Page 15: Error Code Display
7. DISPLAY AND DELETE OF SINGLE DATA After power has been on for 5 seconds, press & hold buttons at the same time, single trip riding time (TM) and single trip distance (DST) will flash. Press button shortly to reset this back to 0. Press & Hold to return to main menu. -
Page 16: Battery Range
OUTLINE DRAWINGS AND DIMENSIONS 1. Dimensions of main instrument body BATTERY RANGE The range of the battery is up to 60 miles per charge. of factors Regular prolong the life of your battery. riding Battery size, tyre pressure, temperature, battery age and weather conditions. (15.5mph) 120kg (19 stone). -
Page 17: Cleaning The Bike
CLEANING THE BIKE Do not use excessive water to clean the bike as this could damage the components, resulting in personal injury or malfunction of the bicycle. Lubricate the chain after every wash if you can to keep it smooth and rust free. Suitable products are available via westhillbikes.com. - Page 18 Be aware of your surroundings. any electrical parts without contacting the Customer Service (+44 (0)1823 672 970). the bike. fb.com/westhillbikes | westhillbikes.com...
- Page 19 NOTES fb.com/westhillbikes | westhillbikes.com...
- Page 20 Westhill Bikes Warranty Register Now Through Our Website westhillbikes.com/warranty-registration Simply visit and fill in your information. Register Now Through Facebook The other way to register your new bike is through Facebook. Simply visit our page www.fb.com/westhillbikes or scan the QR code below with your mobile...
Need help?
Do you have a question about the VENTURE and is the answer not in the manual?
Questions and answers