Activating Env Mode - Stryker L10 Instructions For United States Users

To place the light source in Standby mode:
On the default White Light screen, press the touchscreen power button
1.
so it appears gray and the word "Standby" appears above it.
1

Activating ENV Mode

Endoscopic Near-Infrared Visualization (ENV) mode activates the Class 1M
laser in the light source and enables fluorescence imaging.
Before using ENV mode, read and follow all warnings in this
user manual. Use of controls or performance of procedures
other than those specified can result in hazardous radiation
exposure. Laser emissions from the light source in ENV mode
can cause injury to the user or patient's eyes.
See the ENV Mode Requirements section for equipment
requirements. Use ENV mode only with the specified
equipment.
Note: See the 1588 AIM Video Camera user manual (P29923 English, P29924
multilingual) for additional controls over ENV fluorescence.
Follow the steps below to activate ENV mode.
1. Ensure an AIM SafeLight cable is connected to the light source. ENV mode
will not function unless an AIM SafeLight cable is properly connected. See
the Connecting a Light Cable section for more information.
Note: When an AIM SafeLight cable is properly connected to the light
source, an image of a light cable with a green connector will appear at
the top-right of the touchscreen in ENV mode.
17