Roborock S6 Manual
  1. Manuals
  2. Brands
  3. Roborock Manuals
  4. Vacuum Cleaner
  5. S6 MaxV
  6. Manual

Roborock S6 Manual

Robotic vacuum cleaner
Hide thumbs Also See for S6:

Advertisement

Table of Contents

Roborock S6 Robotic Vacuum Cleaner Manual
Read this manual carefully before using the product and store it properly.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the S6 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Roborock S6

Summary of Contents for Roborock S6

  • Page 1 Roborock S6 Robotic Vacuum Cleaner Manual Read this manual carefully before using the product and store it properly.

  • Page 2: Table Of Contents

    Safety Information ..01 Table of Faults ..06 Welcome ..07 Product Introduction ..08 Installation ..13 Instructions for Use ..17 Routine Maintenance ..21 Basic Parameters ..26 Troubleshooting ..

  • Page 3: Safety Information

    Safety Information Restrictions This product is designed for indoor floor cleaning only, do not use it outdoors (such as on an open-ended terrace), on any surface other than the ground (such as a sofa), or in any commercial or industrial environment. Do not use this product on elevated surfaces without barriers such as the floor of a lo , an open-ended terrace, or on top of furniture.
  • Page 4 Safety Information This product is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the pro- duct by a person responsible for their safety (CB). This product can be used by children aged from 8 years and above and persons with reduced physical,sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of...
  • Page 5 Safety Information Do not use the product on burning objects (such as cigare e bu s). Do not use the product on high pile carpets (product effectiveness may also be reduced on dark carpets). Do not use the product to clean hard or sharp objects (such as decoration wastes, glass and nails).
  • Page 6 Do not charge non-rechargeable ba eries. For the purposes of recharging the ba ery, only use the detachable supply Unit Roborock CDZ08RR or CDZ09RR provided with this product. Do not dismantle, repair or modify the ba ery or charging dock.
  • Page 7 Safety Information Make sure the product is powered off before shipment. Use of the original packaging is advised. If to be le unused for a long period of time, fully charge the product and switch it off before storing it in a cool, dry place. Charge it at least every three months to avoid over discharging the ba ery.

  • Page 8: Table Of Faults

    Table of Faults Table of Faults Item Fault Functions do not work. Main Unit Does not power on. Main brush, side brush, fan or main wheel issue. Charging dock Main unit does not charge. Power cable Charging dock has no power.

  • Page 9: Welcome

    Roborock is dedicated to pu ing the most advanced technologies to work making your life easier. With your new Roborock S6 product doing the hard work, you can focus on doing the things you truly enjoy.

  • Page 10: Product Introduction

    Product Introduction Main Unit Spot cleaning Press to start spot cleaning Clean/On and Off Press to start cleaning Press and hold to power on or off Power light White: ba ery level ≥ 20% Red: ba ery level ＜ 20% Slow flashing: Charging or starting up Red flashing: Error Recharge...
  • Page 11 Product Introduction Part list Adjustable water tank Mop cloth Mounting plate – Disposable mop cloth disposable mop cloth Air filter Water filter Damp-proof mat Power cable Charging dock...
  • Page 12 Product Introduction Dustbin Main Unit Dustbin cover Dustbin latch WIFI indicator Off: WIFI is disabled Slow flashing: Air filter Waiting for connection Fast flashing: Connecting Stable light: WIFI is connected System reset bu on Speaker Main brush cleaning tool Air outlet...
  • Page 13 Product Introduction Main Unit and sensor Wall sensor Recharge sensor Cliff sensor Omni-directional wheel Bumper Charging contacts Side brush Main wheel Main brush Main brush latch Cliff sensor Laser distance sensor Height sensor...
  • Page 14 Product Introduction Mopping module Water tank cover Water filters Mopping cloth slot Water tank Mop cloth latch A achment Water tank point Water control switch Water tank latch Charging Dock Transmission zone Rear cover Charging dock indicator Cable slot Contact point Power connector Contact point Cable slot opening...

  • Page 15: Installation

    Installation Setup 1. Clip the damp-proof mat onto the charging dock using the 3. Power on and charge. guiding grooves. Press and hold the bu on to power on, wait until the ring light turns on, and then place the main unit onto the charging dock to charge.
  • Page 16 Scan the QR code to download and install the app. You will be directed to the connection setup page if the app is installed already. Or search "Xiaomi Home" in the app Store to download and install it. Note: For specific connection instructions, visit the Roborock website and download guidelines for iOS and Android devices. Add Device Open Xiaomi Home app, tap "+"...
  • Page 17 Installation Using the mop 5. Install the mopping module. b. Installing a disposable mop cloth b1. Installing the disposable mop cloth plate Adjusting the water flow rate Insert the disposable mop cloth plate from right to le along Adjust the water flow rate according to your preferences. the slot on the water tank as shown then press it firmly in place.
  • Page 18 Installation Using the mop 6. Start cleaning Refill the water tank When the power light changes from a slow white flash to a Open the water tank, fill the tank with water, then reseal it steady light, charging is complete. Press the bu on carefully.

  • Page 19: Instructions For Use

    Instructions for Use On / Off Press and hold the bu on to power on the main unit. Notes: Cleaning cannot be started if the ba ery level is too low. Recharge ba ery The power light will turn on and the main unit will enter standby then restart cleaning.
  • Page 20 Instructions for Use Charge Spot cleaning Auto mode: A er cleaning, the main unit will automatically In standby or pause mode, press the Spot Cleaning bu on to return to the charging dock for charging. start spot cleaning. This mode cleans a 16.4 (1.5m) square Manual mode: In pause mode, press the bu on to start area centered on the product.
  • Page 21 Instructions for Use The following features can be activated in the App Room cleaning Clean the specified target area Send the product to clean specific rooms of your home. Mark specific points on a map for cleaning and the product will navigate to them automatically.
  • Page 22 Instructions for Use No-go Zones/Barrier tape Refilling the water tank or cleaning the mop cloth mid-clean If refilling the water tank or cleaning the mop cloth during a clean, press any bu on to pause the cleaning cycle and remove the mop module.

  • Page 23: Routine Maintenance

    Routine Maintenance Main brush Clean weekly 1. Flip the main unit over and push the latch to remove the main Lock indicator brush cover. Unlock indicator 2. Li the main brush out then remove and clean the bearing. Main brush 3.
  • Page 24 Routine Maintenance Dustbin and filter Clean the filter Clean bi-weekly Clean weekly 1. Open the top cover of the main unit and press the dustbin 1. Open the dust bin cover as indicated by the arrow. latch to release and remove the dustbin. 2.
  • Page 25 Routine Maintenance Ba ery Clean the filter Clean bi-weekly 3. Remove the filter and rinse with water. The product is equipped with a high-performance lithium-ion rechargeable ba ery. To maintain optimum ba ery perfor- mance, keep the main unit charged. Note: If the main unit is to be le unused for a prolonged period of time, power it off...
  • Page 26 Wheel body Axle Disposable mopping cloth Rack Remove and discard used mop cloth, and replace it with a new one when required. Note: Visit www.roborock.com to purchase additional disposable mop cloths. Note: The omni-directional wheel bracket cannot be removed.
  • Page 27 Routine Maintenance Reset system Main unit sensors If bu ons are unresponsive or the main unit cannot be shut Use a so dry cloth to wipe and clean all sensors, including: down, reset the system by pressing the Reset bu on (refer to 1.

  • Page 28: Basic Parameters

    Basic Parameters Main Unit Charging Dock Name Specs Name Specs Model roborock S6 Model CDZ08RR or CDZ09RR Dimensions 353×350×96.5 mm Dimensions 160×232×116 mm Ba ery 14.4 V / 5200 mAh lithium ba ery Power rating 42 W Weight About 3.6 kg...

  • Page 29: Troubleshooting

    Troubleshooting When a runtime error occurs, the power light flashes red quickly and a voice prompt is given. Please use the table below to solve the problem. Fault display Solution Error 1: Turn the laser unit and check that it is not jammed The laser is stuck or has been blocked.
  • Page 30 Malfunction due to an internal error. Reset the system. Note: Rese ing the system may solve some problems. If the problem persists a er using the recommendations in the table above, please email our a er-sales service team: US/Non-Europe Support: support@roborock.com Europe Support: support@roborock-eu.com...

  • Page 31: Faqs

    FAQs Problem Type Solution The ba ery level is low. Please put the main unit back onto the charging dock to Unable to power on charge it before use. Ba ery temperature is too low or too high. Please use the main unit in the range of 39°F (4°C) ~ 104°F (40°C).
  • Page 32 FAQs The ba ery level is low. Scheduled cleaning is not working Scheduled cleaning can start only if the ba ery level is above 20%. Is the ba ery being drained if the main unit sits on the The ba ery usage is extremely low when the main unit sits on the charging charging dock? dock, which helps maintain optimal ba ery performance.

  • Page 33: Eu Declaration Of Conformity

    EU Declaration of Conformity Hereby we: Name of manufacturer Beijing Roborock Technology Co.,Ltd. Floor6, Suite6016, 6017, 6018, BuildingC, Kangjian Baosheng Plaza, Address No.8 Heiquan Road, Haidian District, Beijing, P.R.CHINA declare that this DoC is issued under our sole responsibility and that the products:...
  • Page 34 EU Declaration of Conformity 1.Electromagnetic Compatibility (EMC) standard for radio equipment and services; Part 1: Common technical requirements; Harmonized Standard covering the essential requirements of article 3.1(b) of Directive 2014/53/EU and the essential requirements of article 6 of Directive 2014/30/EU RED Directive 2014/53/EU 2.Electromagnetic Compatibility (EMC) standard for radio equipment and services;...
  • Page 35 EU Declaration of Conformity 1.Household and similar electrical appliances-Safety-Part 1: General requirements Low Voltage Directive 2014/35/EU 2.Household and similar electrical appliances-Safety-Part 2-29: Particular requirements 1. EN 60335-1:2012 + A11:2014 for ba ery chargers 2. EN 60335-2-29:2004 + A2:2009 3.Measurement methods for electromagnetic fields of household appliance and similar 3.

  • Page 36: Weee Information

    WEEE Information Correct Disposal of this product . This marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources.

  • Page 37: Warranty Information

    Warranty Information Warranty Information The seller provides warranty in accordance with the legislation of the customer's own country of residence, with a minimum of 1 year,starting from the date on which the appliance is sold to the end user. The warranty only covers defects in material or workmanship. The repairs under warranty may only be carried out by an authorized service centre.

Table of Contents

Save PDF