Installing the Processor
1. Insert the processor into the processor socket. Ensure that the processor is properly seated.
2. Press the release lever down and then move it inward to secure it with the retention hook.
3. Install the:
a)
hard drive
b)
cover
4. Follow the procedures in
Removing the Memory
1. Follow the procedures in
2. Remove the:
a)
cover
b)
processor fan module
3. Pry the retention clips away from the memory module until it pops-up. Lift and remove the memory module from its connector.
Installing the Memory
NOTE:
Please use DIMM 2 slot if there is only one memory module available.
1. Align the notch on the memory-card with the tab in the system-board connector.
2. Press down on the memory module until the retention clips spring back to secure them in place.
3. Install the:
a)
processor fan module
b)
cover
4. Follow the procedures in
Removing the Coin-Cell Battery
1. Follow the procedures in
2. Remove the:
a)
cover
b)
hard drive
c)
PS2 and serial connector board
3. Press the release latch away from the battery. The battery pops out from the socket; lift the coin-cell battery out of the computer.
After Working Inside Your
Computer.
Before Working Inside Your
After Working Inside Your
Computer.
Before Working Inside Your
Computer.
Computer.
Extracción e instalación de componentes
29