Standard Contents; Getting Started - Mangar Archimedes User Instructions And Warranty

ME0057 issue 3
B
A
A
B
freedom through lightweight solutions
A
C
B
A
C
C

Standard Contents

1 x Archimedes Bathlift ( inc. two transfer flaps ) (A fig.1).
1 x Sealed Hand Control (B).
1 x Battery charger (C).
2 x Flap Guards (with instructions).
1 x User Instructions.

Getting Started

Unpacking - Remove the contents from the packaging
and check them to make sure that no damage has been
caused during transit. If it has, contact your supplier
immediately.
1
Battery - This must be put on charge before using your
Archimedes for the first time as follows:
• Connect the hand control to the battery charger
and plug the charger into a power supply OUTSIDE
THE BATHROOM and allow the battery to charge
overnight (see "Battery Charging").
Seat and base sections - The Archimedes can be easily
separated into three sections (fig.2).
• Seat section (A)
• Base section (B)
• Actuator (C)
2
To separate the seat
actuator:
• Fully lower the seat and fold the transfer flaps onto
the seat.
• Release the transit tie (A fig.3) by pulling up the 'O'
ring and lifting the ball clear of the slot in the locating
collar on the actuator.
• Press the lower part of the latch at the back of the
seat (A fig. 4) and lift the seat sufficiently to allow the
3
actuator to disengage itself from the slot (B) and the
actuator locator bracket (C). The actuator can now
be removed from the base section.
• Lift the seat section clear of the base section.
• Reassemble in the reverse order. Do not re-attach
the transit tie unless you are intending to carry the
assembled Archimedes.
The transit tie should only be re-attached to the back of
the seat section in order to keep both the seat and base
4
sections together whilst carrying the Archimedes.
archimedes
from the base section and
3