Related Manuals for SMART/RG SR360n
Summary of Contents for SMART/RG SR360n
- Page 1 Quick Start Guide SR360n This Quick Start Guide shows you how to set up and begin using your new gateway.
-
Page 2: Installation
INSTALLATION Connect one end of the supplied DSL cable to the port labeled DSL on the gateway and connect the other end t the DSL wall jack installed by your provider. For all other devices, connect an Ethernet cable from that device to any of the LAN ports on the gateway. - Page 3 5 min...
-
Page 4: Led Indicators
LED INDICATORS The LEDs on the front of SR360 can assist you in better understanding the current state of your gateway. POWER LAN 1-4 WLAN INTERNET DSL sync in progress DSL sync acquired and gateway online Gateway online and data transfer in progress IP connection failure WiFi enabled on modem PC / network activity / data transfer... -
Page 5: Quick Gateway Configuration
QUICK GATEWAY CONFIGURATION Logging in to your gateway To change the settings on your gateway, you must log in the gateways' interface. Make sure that you have completed the steps in "INSTALLATION" before you begin. Open your internet browser application and type 192.168.1.1 into the address line. - Page 6 The following screen appears. Wait while the gateway connects to your service pro- vider. When the connection is complete, appears in green letters next to the Net- work icon. Click the Manage gateway (advanced) link in the upper right. The login dialogue appears.
- Page 7 You may log in with the factory default credentials shown below. User Name: admin Password: admin Click the Log In button in the lower right. Note: Your service provider may use other settings. Please contact your provider for login information. Manual Configuration of the WAN If the automatic connect process is unsuccessful, refer to the Advanced Setup >...
- Page 8 WiFi Setup Two methods, WPS and Manual, are available for WiFi setup. Perform the steps on this page for both methods, and then follow the instructions for the method you desire. In the left navigation bar, click Wireless ->Basic. If not already selected, click Enable Wireless.
-
Page 9: Wps Method
WPS Method If the device you wish to connect to the Internet via your SmartRG gateway sup- ports the WPS secure WiFi connection method, you may follow these steps. 1. In the left navigation bar, click Wireless -> Security. 2. Select Enable WPS and click Apply/Save... -
Page 10: Manual Method
Manual Method Set up your gateway’s parameters first, then: 1. In the left navigation bar, select Wireless > Security and scroll down to the Manual Setup AP section. 2. If your gateway supports multiple wireless networks, select the SSID of the network you wish to configure. -
Page 11: Additional Support
RECORD YOUR SR360N WIFI SETTINGS Preset wireless settings on your If you change the preset wireless router settings WiFi network name (SSID) Network key (pass- word) ADDITIONAL SUPPORT If you require further instructions, please contact your local ISP Support. SMARTRG INC. ALL RIGHTS RESERVED. COPYRIGHT 2018 ©...
Need help?
Do you have a question about the SR360n and is the answer not in the manual?
Questions and answers