Eaton iLIGHT TSE55 Installation Manual

TSE55 - Colour Touchscreen
Installation guide
Planning the installation
TSE55 requires a minimum mounting depth of
20mm from the front wall surface plus room
for cable/s. Power is supplied by Power Over
Ethernet (PoE). PoE must meet the IEEE 802.3af
standard. TSE55 connects to the local network
via a hard wired Ethernet connection.
Back Box
Mounting Bracket
PoE and Data Connection (RJ45)
Mounting height
The recommend mounting height for the
TSE55 is 145 cm -165 cm above the finished
floor to the center of the unit.
Installation
TSE55 has been designed to mount to a Standard UK
single gang back box, a standard European single gang
back box as well as a standard US NEMA single gang
back box. Minimum depth: 47mm
The mounting frame, included with this unit, should be
attached to the back box using the screws supplied
with the back box.
TSE55
Installing the mounting frame
TSE55 includes a mounting frame that MUST be used
for this installation.
Using the screws supplied with the backbox, mount
the mounting bracket onto the back box
Mounting the TSE55
Align the mounting frame
hooks with the TSE55
mounting slots and gently
push the TSE55 unit onto
the mounting bracket.
Make sure the mounting
hooks are properly
engaged.
UK EURO NEMA
Tighten the 2 captive
screws (one at each side)
to secure the TSE55 to
the mounting bracket