Datalogic Matrix-2000 Quick Reference Manual

1
1 Reading Window
2 Positioning LED
3 Keypad button
4 Calibration LED
For further details on product installation, see the complete Installation Manual available on
the CD included with this product.
NOTE
Compliance:
- This product is intended to be installed by Qualified Personnel only.
- This product is intended to be connected to a UL Listed
Computer which supplies power directly to the reader or a
UL Listed Direct Plug-in Power Unit marked LPS or
"Class 2", rated 10 to 30 V, minimum 1 A.
- In order to meet the EMC requirements:
•
connect reader chassis to the plant earth ground by
means of a flat copper braid shorter than 100 mm;
•
connect the main interface cable shield to pin 1 of the
reader 25-pin connector;
•
use two clip-on ferrite sleeves (type Stewart 28A2029-
0A0) on the main interface cable near the reader 25-
pin connector;
•
connect the Ethernet interface cable shield to the
reader chassis (for Matrix-21XX only)
Model Description:
Device Connectivity
0 = RS232/RS485 + RS232
1 = RS232/RS485 + RS232+ Ethernet
Matrix-2000™
Quick Reference Guide
5
6
7
8
Figure A
5 Communication LED
6 Main/Auxiliary Interface
Ethernet Interface (for 21XX
7
models only)
MATRIX - 2XXX-X
Optics
1 = Ultra High Density (UHD)
2 = High Density (HD)
3 = Standard Density (SD)
4 = Low Density (LD)
5 = Medium Range (MR)
6 = Long Range (LR)
10
11
9
Auxiliary Interface
8
Good Read LED
9
10 External Trigger LED
Power On LED
11
TO EN 60825-1:2001
Image Sensor
1 = VGA CCD
5 = SXGA CMOS
4
3
2
Other Options
R = 90° Reading Window