Philips ROADFOCUS RFS Installation Instructions

READ THESE INSTRUCTIONS CAREFULLY BEFORE INSTALLING THIS FIXTURE
CAUTION: THE ELECTRICAL POWER MUST BE DISCONNECTED BEFORE OPENING THE FIXTURE
FAILURE TO FOLLOW THE INSTALLATION DOCUMENTATION OR OPERATING THIS PRODUCT
OTHERWISE THAN FOR ITS INTENDED USE VOIDS THE WARRANTY
1. Push the latch to release the access door
2. Install the bird guard for ø1.9'' or ø1.66'' OD tenons before
sliding the fixture onto the tenon. See the important note below
3. Disconnect power and slide the fixture onto the tenon. See table for
approximate penetration. Horizontal angle can be adjusted in 2.5° steps
A shorting cap, photo control
or other compatible device
must be installed
1
Latch
IMPORTANT : Install the bird guard for ø1.9" or ø1.66" OD tenons
FAILURE TO DO SO VOIDS THE WARRANTY
For ø1.9" tenon, unfold the bird guard
as shown and break away the smaller
diameter lid at the folding line
±5°
TENON
PENETRATION
ANGLE RFS/RFM RFL
-5° 4" 5.5"
-2.5° 4.5" 5.9"
0° 4.8" 6.2"
2.5° 5" 6.5"
5° 5.5" 7"
Tighten the two bolts
(four bolts on RFL)
@ 135 lbs.in (11.25 lbs.ft)
ROADFOCUS
INSTALLATIONINSTRUCTIONS
Bubble
Level
FAWS
(option)
Bird guard
installed location
-5°
0°
5°
RFS/RFM/RFL
Access door
Tenon
2
L
3
4. Evenly tighten the two bolts (4 on RFL)
of the bracket. IMPORTANT: Tighten the
two bolts at 135 lbs.in (11.25 lbs.ft)
5. Connect the service leads to the
terminal block. Tighten the
set-screws between 20 and 25 lbs.in
4
RFS RFM
If required, place
the supplied
ANSI sticker as
shown
To change the
orientation of the
socket, loosen the
two screws, orient
it and tighten both
screws
3 poles
Terminal Block
2-14 AWG
N
1/2
442100171450-REV0
RFL
5
Tenon