Advertisement
Quick Links
4
VESTA FIXTURE
TOOLS NEEDED:
D
PHILLIPS SCREWDRIVER
RUBBER MALLOT
LEVEL
ND + 0.5
BASE TABLE
C
1.000
INT DIVIDER
PANEL
1.500
SLOTTED
B
END
A
4
3
UFDPUSEF
VESTA FIXTURE
DIVIDER PANEL UPRIGHT
SLOTTED END FRAME
UFDT
VESTA FIXTURE
BASE DISPLAY TABLE
ND + 0.5
BASE
DRAWER
2.000
END DIVIDER
NW + 1
NW
C L
C L
20140221
3
2
REV.
01
NW + 1
1.000
PANEL
2
DESCRIPTION
CHANGED NAME FROM ULTRA TO VESTA
UFGC
VESTA FIXTURE
GONDOLA CORE
UFBD
VESTA BASE DRAWER
UFDPUE
VESTA FIXTURE
DIVIDER PANEL UPRIGHT END
ASY-80034772
© 2013 Madix Inc., All rights reserved
20984 AL HWY 9 GOODWATER, AL 35072
PO BOX 729 TERRELL, TX 75160
256-839-6354 / 214-515-5400 / 800-776-2349
ARB
2/21/14
1
DATE
2/21/2014
D
UFDPUI
VESTA FIXTURE
DIVIDER PANEL
UPRIGHT INTERMEDIATE
C
B
A
SHEET 1 OF 8
REV. 01
ECM # 500000014190
1
Advertisement
Related Manuals for Madix VESTA FIXTURE
Summary of Contents for Madix VESTA FIXTURE
- Page 1 VESTA BASE DRAWER UFDPUE VESTA FIXTURE DIVIDER PANEL UPRIGHT END ASY-80034772 © 2013 Madix Inc., All rights reserved 20984 AL HWY 9 GOODWATER, AL 35072 PO BOX 729 TERRELL, TX 75160 SHEET 1 OF 8 256-839-6354 / 214-515-5400 / 800-776-2349 REV.
- Page 2 UFGC VESTA FIXTURE UFDPUSEF VESTA FIXTURE VESTA FIXTURE GONDOLA CORE © 2013 Madix Inc., All rights reserved DIVIDER PANEL UPRIGHT SLOTTED END FRAME UFDPUI VESTA FIXTURE DIVIDER PANEL UFDPUE UPRIGHT INTERMEDIATE VESTA FIXTURE DIVIDER PANEL UPRIGHT END UFDT VESTA FIXTURE...
- Page 3 VESTA FIXTURE STEP 1 : PEEL PROTECTIVE COVERING FROM © 2013 Madix Inc., All rights reserved ALL PLASTIC BACK PANELS BEFORE INSTALLATION. STEP 2: INSERT (2) PANELS INTO TRACKS IN FRAME HINT: DUE TO THE HIGH HEAT OF THE WELDING...
- Page 4 VESTA FIXTURE © 2013 Madix Inc., All rights reserved INSERT THE CONNECTORS ON THE END DIVIDER PANEL(CONNECTORS WILL ONLY BE ON ONE SIDE ON AN END DIVIDER) INTO OPEN END OF TUBES ON THE SIDE OF THE GONDOLA CORE WHILE PRESSING SNAP BUTTON ON BOTTOM.
- Page 5 VESTA FIXTURE © 2013 Madix Inc., All rights reserved INSTALL INTERMEDIATE DIVIDERS THE SAME AS THE ENDS WERE INSTALLED. INTERMEDIATE DIVIDERS HAVE CONNECTORS ON BOTH SIDES. INTERMEDIATE DIVIDERS WILL BE USED UNTIL YOU ARE AT THE END OF THE RUN, THEN YOU WILL INSTALL ANOTHER END OR A SLOTTED END FRAME.
- Page 6 VESTA FIXTURE © 2013 Madix Inc., All rights reserved PUSH DRAWER UP TO CORE, AND HOOK INTO SLOTTING. YOU CAN REMOVE THE DRAWER OUT OF THE DRAWER BODY TO MAKE THIS EASIER BY PULLING DRAWER ALL THE WAY OUT, AND PUSHING LEVERS ON THE DRAWER SLIDES TO RELEASE.
- Page 7 VESTA FIXTURE © 2013 Madix Inc., All rights reserved THE VESTA BASE TABLE CAN TAKE A LEDge LIGHT. IF LIGHTING IS NEEDED, SIMPLY SET LIGHT STICK MAGNET SIDE DOWN INTO THE REAR OF TABLE, AND FOLLOW LEDge INSTALLATION INSTRUCTIONS. TO INSTALL BASE TABLE...
- Page 8 VESTA FIXTURE © 2013 Madix Inc., All rights reserved ANY 2 TAB MADIX SHELVING MAY BE USED WITH THE ULTRA FIXTURE PICTURED ARE OUR STRAIGHT IN UFUSA SHELVES WHICH HOOK STRAIGHT INTO THE CORE, OR END FRAME. DETERMINE IF VERSA BUS BAR...
Need help?
Do you have a question about the VESTA FIXTURE and is the answer not in the manual?
Questions and answers