1. Manuals
  2. Brands
  3. LCI Manuals
  4. Accessories
  5. Solera Classic Awning
  6. Owner's manual

LCI Solera Classic Awning Owner's Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
®
More information https://www.caravansplus.com.au

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Solera Classic Awning and is the answer not in the manual?

Questions and answers

Related Manuals for LCI Solera Classic Awning

Summary of Contents for LCI Solera Classic Awning

  • Page 1 ® More information https://www.caravansplus.com.au...

  • Page 2: Table Of Contents

    Maintenance - Solera Awnings Fabric Care Introduction The Solera Classic Awning is designed for use on most recreational vehicle units and is available in a variety of sizes to fit even the largest unit. Additional information about this product can be obtained from www.lci1.com/support...

  • Page 3: Safety

    Failure to correctly follow the provided instructions may result in death, serious personal injury, severe product and/or property damage, including voiding of the LCI limited warranty. The “WARNING” symbol above is a sign that a procedure has a safety risk involved and may cause death or serious personal injury if not performed safely and within the parameters set forth in this manual.

  • Page 4: Optional Car Port Position

    Pull on the mount/rafter arm to ensure the fabric is taut and tighten the black locking knob to lock it into place. Raise the outer arms to the desired height by releasing the support arm assembly handle and allow the outer arm upper channel (channel #1) (Fig. 1) to slide on the outer arm lower channel (channel #2) (Fig.
  • Page 5 NOTE: If the awning is 6’ in length it will only need one cotter pin for the drive side end cap. Pull on the mount/rafter arm to ensure the fabric is taut and tighten the black locking knob to lock it into place.

  • Page 6: Installing Replacement Fabric

    Installing Replacement Fabric Unroll the replacement fabric so that the polycords are parallel with the roll tube. Gently slide the roll tube on to the two polycords of the fabric, making sure that the non-printed side is touching the roll tube (Fig. 4). Center the fabric on the roll tube.
  • Page 7 10. Unroll the fabric from the roll tube to allow the drive/idler head assemblies to be installed into the outer arms. 11. Install the previously-removed drive head assembly and idler head assembly retaining bolts into the outer arms to secure the components. 12.
  • Page 8 What is happening? Why it's happening What should be done? Cam lock engaged. Check position of the cam lock (roll out). Ensure that the travel locks have been released from Travel locks engaged. the outer arm. Rafter arm(s) locking Make sure the locking knob for the rafters has been Awning will not extend.

  • Page 9: Maintenance - Solera Awnings

    Troubleshooting Continued What is happening? Why it's happening What should be done? Check the cam lock. Signs of a faulty cam lock include: Cam lock wear may be - The absence of a clicking noise when the awning is Awning will not stay in the rolled out position.
  • Page 10 LCI representative has been provided.  Any unauthorized use shall void any applicable warranty.  The information contained in this manual is subject to change without notice and at the sole discretion of LCI.  Revised editions are available for free download from lci1.com.

Table of Contents