Medway Easy Toilet Riser Quick Manual

Remove your Existing T oilet
Step 1
Turn off the water supply
to the to the toilet
Step 2
Then flush the toilet.
Step 3
Use a plunger and a
sponge to get the water
out of the bowl
Step 4
Using a bucket, unhook
the water supply and
drain the remaining
water from the toilet's
tank.
Step 5
Remove the existing
closet bolts from the
toilet.
Step 6
Remove the existing
toilet.
Step 7
Remove the old wax ring
and closet bolts
Install the Easy T oilet Riser
Step 8
Slide in the new extend-
ed 6 inch closet bolts in
the existing flange
Step 9
Place one of the wax
rings provided in the kit
on top of the flange
Step 10
Carefully install the
toilet riser over the
closet bolts
Step 11
Apply pressure to the top
of the Riser to properly
seal the wax ring with
the existing floor flange
Step 12
Place the second wax
ring on to the riser flange
(optional step) if you ordered the
Medway 19" Easy Toilet Riser
Step 13
Place the 19" riser apron
over the base riser and
adjust as necessary to
accomodate your toilet
Re-install your old T oilet
Step 14
Reinstall the toilet on top
of the toilet riser
Step 15
Apply pressure on the
bowl to properly seat the
toilet.
Step 16
Install nuts and washers
Step 17
Do not over tighten
Step 18
Install the new water
supply line and turn on
the water
Step 19
Congratulations! You can
now use your new raised
toilet!
The Medway Easy Toilet Riser can normally
be installed in less than an hour by most
handy persons.