Stabilizer - Lowrance Ghost Series Installation Manual
Hide thumbs
Also See for Ghost Series:
- Installation manual (32 pages) ,
- Operator's manual (32 pages) ,
- Operator's manual (24 pages)
Table of Contents
Advertisement
16 |
Stabilizer
The stabilizer is used to support the trolling motor when in stowed position.
! Warning:
If the stabilizer rod is too long it can prevent proper latching of the trolling motor
in the stowed position. If the stabilizer rod is too short, it will cause inadequate support of the
trolling motor. Improper latching or support may cause damage.
Parts required
Item
Qty
A
1
B
1
C
1
D
1
Tools required
•
Hack saw
•
File
•
Wrench
Procedure
1
Place the motor in the stowed position. Measure the proper length of the stabilizer rod by
placing it, with the threaded end down, onto the deck surface so that it is parallel to the
stabilizer rod adapter. Mark the rod 20 mm (0.75") past the top of the stabilizer rod adapter.
C
2
Cut the rod. Remove any sharp edges around the cut.
3
Attach the foot cap and screw down the jam nut on the stabilizer rod. Install the stabilizer rod
into the adapter located on the 360 breakaway.
Installation |
Ghost Series Installation Manual
Description
Top cap
Jam nut 3/4"-10
Stabilizer rod
Foot cap
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Ghost Series and is the answer not in the manual?
Questions and answers
The anchor function on my foot pedal stopped working yesterday; when I push that with my foot nothing happens; how do I diagnose and fix this?
To diagnose an anchor function issue on your Lowrance Ghost Series foot pedal, check for error indicators:
1. Listen for Beeps and Check LED Flashes
- 3 short beeps, 2 short flashes: Missing GPS signal.
- 4 short beeps: Invalid heading data, check compass connection.
- 5 long flashes: Battery level low, unit will shut off.
- Fast double flashes: Hardware error, perform a power cycle.
2. Perform a Power Cycle
- Turn off the unit, wait a few seconds, then turn it back on.
3. Check Compass Connection
- Ensure all cables and connectors are properly attached.
4. Force a Software Upgrade (if needed)
- If experiencing a software mismatch, enter user configuration mode, then hold the Anchor key and Configurable key 3 to initiate an upgrade.
If the issue persists, contact a service center.
This answer is automatically generated