Do you have a question about the 5000 Series and is the answer not in the manual?
Questions and answers
Susan Himmelstrup
March 15, 2025
None of the buttons on the radio is working
1 comments:
Mr. Anderson
March 15, 2025
The buttons on the Philips 5000 Series radio may not be working due to the following reasons:
1. The radio may be in standby mode – If the radio is in standby mode, turn it on. 2. Power issue – Disconnect and reconnect the AC power plug, then turn the radio on again.
If the issue persists, ensure the device is receiving power and try resetting it.
Contents Important Product information Safety Troubleshooting Your FM/DAB radio Introduction Notice What's in the box Compliance Overview of the main unit Care of the environment Trademark notice Get started Prepare radio antenna Connect power Turn on Adjust the volume level Switch to standby mode Listen to DAB radio Tune to DAB radio stations...
1 Important • Install in accordance with the manufacturer's instructions. • Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. Safety Warning • Never remove the casing of this radio. •...
2 Your FM/DAB radio Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www. philips.com/welcome. Introduction With this radio, you can: • listen to FM and Digital Audio Broadcasting (DAB) radio;...
Overview of the main unit • Turn on the radio. • In Bluetooth mode: Press to skip to the previous track. • Switch to standby mode. • In Tuner mode: Tune to a radio SOURCE station. • Select a source: Bluetooth, DAB or FM •...
3 Get started Option 2: Battery power Caution • Batteries (battery pack or batteries installed) Always follow the instructions in this chapter in shall not be exposed to excessive heat such as sequence. sunshine, fire or the like. • Danger of explosion if battery is incorrectly replaced. Replace only with the same equivalent type.
4 Listen to DAB In DAB mode, tune to a DAB radio station. Press and hold PRESET for two seconds. radio The Preset store is displayed. Press to select a preset number. Press Ielect to confirm. Tune to DAB radio stations [Preset stored] is displayed.
Select a preset DAB radio Use menu in DAB mode station In DAB mode, press and hold In DAB mode, you have two ways to select a access DAB menu. preset radio station. Press to scroll through the menu options: Option A: •...
5 Listen to FM Press and hold button to do auto scanning for the broadcasting radio radio channels, press it again to stop auto scanning. • To remove a pre-stored station, store another Tune to FM radio stations station in its place. Press SOURCE repeatedly to select [FM] mode.
Use menu in FM mode Show FM information While listening to FM radio, press In FM mode, press and hold to access repeatedly to scroll through the following FM menu. information (if available): Press to scroll through the Radio mode menu options: •...
On your Bluetooth device, enable • To return to the previous menu, press Bluetooth and search for Bluetooth devices. Select [Philips R5505] from search results Note and tap to connect • If no button is pressed within 15 seconds, the After successful connection, the screen menu exits.
2,4 Ghz ~ 2,48 GHz Band ISM Band Maximum transit -4.1 dBm power Bluetooth Range 10 m (free space) General information AC Power Brand name: PHILIPS (power adapter) Input: 100-240V-, 50/60HZ Output: 7,5V = 1.0A Operation Power ≤8W Consumption Standby Power ≤1W...
If you encounter problems when using this device, check the following points before requesting service. If the problem remains unsolved, go to the Philips Web page (www. philips.com/support). When you contact Philips, make sure that the device is nearby and the model number and serial number are available.
Directive 2014/53/EU. You can a specialized company Please observe the find the Declaration of Conformity on www. local regulations regarding the disposal of philips.com/support. packaging materials, exhausted batteries and old equipment. Care of the environment Trademark notice...
Page 15
Specifications are subject to change without notice. Philips and the Philip Shield Emblem are registered trademarks of Koninklijke Philips N.V.and are used under license. This product has been manufactured by and is sold under the responsibility of MMD Hong Kong Holding Limited or one of its affiliates, and MMD Hong Kong Holding Limited is the warrantor in relation to this product.
Need help?
Do you have a question about the 5000 Series and is the answer not in the manual?
Questions and answers
None of the buttons on the radio is working
The buttons on the Philips 5000 Series radio may not be working due to the following reasons:
1. The radio may be in standby mode – If the radio is in standby mode, turn it on.
2. Power issue – Disconnect and reconnect the AC power plug, then turn the radio on again.
If the issue persists, ensure the device is receiving power and try resetting it.
This answer is automatically generated