SPARKLETTS Pure Water Dispenser 500 Series Manual

DIY: HOW TO CLEAN
YOUR WATER DISPENSER
Your water dispenser exterior should be thoroughly cleaned every 6 months, and your
SmartFlo™ water cartridge replaced every 12 months. If you do not have a replacement cartridge
handy, you can order one
include a SmartFlo™ cartridge, bottle adaptor, lid key and plug for the bottle tube:
Before you start cleaning, wash your hands thoroughly with soap and water for at least 20 seconds.
TIP: The best time to replace your water cartridge is when the existing water bottle is empty.
WHAT YOU'LL NEED:
• SmartFlo™ replacement cartridge
• 70% rubbing alcohol or disinfecting wipes
• Clean cloth or soft brush
WARNING: Always use caution when handling hot water.
Fig 1
1. Turn off the hot tank heater switch
on the back of the dispenser and
unplug your unit (Fig 1). Let the unit
stand for one hour before cleaning
to allow the hot tank to cool.
Fig 4
4. Remove cup holders, if applicable.
Open the cooler lid using the key
provided in the replacement kit (Fig 4).
5. Close cooler door. Place a glass or other
container below the water faucets to
catch any drips.
here and it will be shipped directly to you. Your replacement kit will
Fig 2
2. Slide the cooler door up and
remove the empty water bottle
(Fig 2). Wipe interior cabinet
with 70% rubbing alcohol or
disinfecting wipes.
Fig 5
6. Remove the SmartFlo™ cartridge
and bottle tube by unlatching
the blue locking arm and rotating
the two blue knobs to the open
position (Fig 5).
• Rubber gloves
• Bucket
• Towels to absorb any water spills
3.
7.
TIP:
dispose of the used SmartFlo
cartridge and bottle tube,
which will contain water.
Fig 3
Unplug the bottle tube connected
to the neck of the water bottle.
Plug the bottle tube using the red
plug provided in the SmartFlo™
replacement kit (Fig 3).
Fig 6
Pull up on the SmartFlo™ water
cartridge (Fig 6). Do not squeeze
the water reservoir as water could
leak out.
Have a bucket nearby to
TM
™