Leica Laser Alignment Depthmaster 200 Operation/Reference Card

Power Buttons. Press the button on the side you will be viewing to
activate the indicators for that side, or press both at start-up to acti-
vate both sides. The Power Buttons only function when the Battery
Pack powers the Laser Sensor. Otherwise, a Control Panel switch or
connecting to an external battery activates the Laser Sensor.
Hidden Switch. See Optional Functions on back side of sheet.
Grade Position Indicators. Blink rapidly to indicate the position of the
machine's cutting edge relative to grade. (See below.)
Plumb Indicators. Blink rapidly to show the vertical position of the machine's
arm. (See below.)
Low Battery Indicators. Become lit when the Battery Pack has less than 6
hours of operating charge.
Cable Connector. Provides a connection to a Control Panel or to a 12 or 24
Volt DC battery. Use Sensor Cable 40244-05 to connect to a battery: the
black wire to negative; the white wire to positive.
Shake-to-Wake. After 5 minutes of no movement, the Laser Sensor
goes into "stand-by" to conserve power. Move the Laser Sensor to activate it.
(After 90 minutes of no movement, it shuts completely off.)