Cleaning And Maintenance - ROBINHOOD RHCD7W Installation And Operating Instructions Manual

Cleaning and Maintenance

Cleaning and Care
Clean the lint filter
Leave the dryer to cool down.
1. Open the machine door.
2. Take out the lint filter, pull upward to take it out.
3. Clean the lint filter; wipe off the scrap threads accumulated
on the lint filter, with your hand or rinse with water and
dry thoroughly.
4. Reinstall the lint filter.
Note!
The lint filter accumulated on the filter will block the air circulation, which will cause the extension
•
of drying time and energy use; therefore, the scrap thread filter shall be cleaned after each use.
Do disconnect the power cord before cleaning!
•
Do not operate the dryer without the lint filter!
•
Clean the lint filter after each use to prevent lint accumulation inside the dryer.
•
Wash air condenser
Leave the dryer to cool down.
Residual water may escape, place an absorbent cloth under the maintenance
cover.
Unlock the maintenance cover.
1.
Completely open maintenance cover.
2.
Screw both locking levers towards each other.
3.
Pool out the air condenser.
4.
Clean the air condenser completely, drains thoroughly.
5.
Clean the seals.
6.
Re-insert the air condenser, handle at the button!
7.
Unscrew both locking levers.
8.
Cloth the maintenance cover until it locks into position.
9.
Please clean the air condenser approx, once every 3 months if frequently used.
Do not damage the air
Warning!
Clean with water only; do not use hard/sharp-edged objects!
•
Do not operate the dryer without the air condenser!
During drying, water may collect between the window and the
•
seal, but this does not affect the function of your dryer!
15
condenser.