Smartsense Propane Sensor; Pairing Smartsense Propane - BMPRO JAYCOMMAND Manual

The JAYCOMMAND system is able to integrate with
BLE Propane sensors called SmartSense.

PAIRING SMARTSENSE PROPANE

1.
Go to the Energy Center screen where the
propane tank levels are displayed. Pressing
the "Add" button on the Propane tile
2. Choose between 3 bottle sizes.
3. Press the "Pair" button in the
Propane tile
4. To Pair a new sensor quickly press the
orange "Sync" button 6x times.
This permanently disables Sleep Mode, which
is the factory setting. After the first use, only a
single press is required to re-SYNC or connect
a new device.
5. Once pairing is successful, the propane
level will appear.
6.
Next, ensure the base of the tank is clean.
Remove any debris, excess paint or rust.
7.
The sensor mounts to the base of the tank
using magnets. The rubber pad between
the magnets must make good contact
with the tank, with no contaminants
in between and must be aligned to the
center of the tank.
8.
Return the tank to its upright position.
Ensure the tank is on a flat and level
surface or is otherwise level with ground.
Even a slight tilt can degrade the quality
of the measurement. After a few seconds,
up to a few minutes, the propane will
settle, and the readings will stabilize.
24
PROPANE SENSOR
1.
2.
3.
PRESS
SYNC
BUTTON
6x
4.