Download Print this page
Fimco LG-25-BL-ATV Owner's Manual

Fimco LG-25-BL-ATV Owner's Manual

25 gallon lawn & garden/atv boomless sprayer

Advertisement

Quick Links

General Information
Thank you for purchasing this product. The purpose of this
manual is to assist you in operating and maintaining your lawn
& garden ATV sprayer.
BEFORE RETURNING THIS PRODUCT
FOR ANY REASON, PLEASE CALL
1-800-831-0027
MONDAY-FRIDAY, 8:00 AM TO 5:00 PM CST
If you should have a question or experience a problem with
your Fimco Industries Product: Visit our website @
www.fimcoindustries.com or call the Toll free number above. Our
technical support representatives will be happy to help you.
In most cases a customer service rep. can resolve
the problem over the phone.
To obtain prompt, efficient service, always remember to give the
following information....
• Correct Part Description and/or part number
• Model number and Serial Number
Part descriptions and numbers can be obtained from the
illustrated parts list section(s) of this manual.
Retain a copy of your receipt for your
unit, as it will be required to validate
any warranty service.
Warranted against manufacturer or
workmanship defects from date of
purchase with copy of receipt:
Homeowner Usage: Sprayer-One Year and Pump-Two Years.
Commercial Usage: Sprayer and Pump-90 Days.
OWNER'S MANUAL
Model: LG-25-BL-ATV (5302952)
(25 Gallon Lawn & Garden/ATV Boomless Sprayer)
25 Gal. Corrosion-Resistant Polyethylene Tank
12 Volt Diaphragm Pump, 4.5 GPM - 60 PSI
Deluxe Pistol Grip Handgun
20 Ft. Handgun Hose (3/8" I.D.)
26 Ft. Vertical throw, 35 Ft. Horizontal Throw
30 Foot Spray Coverage w/Boom
Corrosion-Resistant Nozzles
Caution: When fully filled with water, this sprayer will
weigh 260 lbs.. Consult the owner's manual for your
vehicle to verify that you are within it's load carrying
capacity.
Make sure the contents of the sprayer's carton match the
items shown on page 2 of the manual.
Follow the steps on pages 3, 4 & 5 to properly assemble
the sprayer.
After assembly is complete and before testing your spray-
er, make sure you connect the electrical hook-up to the
end of your pump and clip the clips to a fully charged bat-
tery.
***IMPORTANT REMINDER***
Detail A
This sprayer comes with an On/Off (shut-off) valve located at the
inlet location of the tank, towards the underside. (See Detail A).
You must make sure the valve is in the 'open' position before using
your sprayer.
1000 FIMCO Lane, P.O. Box 1700, North Sioux City, SD 57049
Toll Free Phone: 800-831-0027 : Toll Free Fax: 800-494-0440
[5195132
Technical Specifications
Assembly Instructions
www.fimcoindustries.com
(02/19)]
Page 1

Advertisement

loading
Need help?

Need help?

Do you have a question about the LG-25-BL-ATV and is the answer not in the manual?

Questions and answers

Summary of Contents for Fimco LG-25-BL-ATV

  • Page 1 1000 FIMCO Lane, P.O. Box 1700, North Sioux City, SD 57049 Homeowner Usage: Sprayer-One Year and Pump-Two Years. Toll Free Phone: 800-831-0027 : Toll Free Fax: 800-494-0440 Commercial Usage: Sprayer and Pump-90 Days.
  • Page 2 Contents of your sprayer’s carton (LG-25-BL-ATV - 5302952): Owner’s Manual Lid w/Lanyard (#5058188) Tank/Plumbing Pre-Assembly “Wet Boom” Sub-Assembly End Nozzle (5275122) (5275712) Pkg. of 2: #5275713 Contents of Parts Bag #5281094 Contents of Bracket Kit #5278138 Page 2...
  • Page 3 Step 1 Step 1 Assembly Procedure (LG-25-BL-ATV) Normally, the sprayer will be mounted on an ATV with the pump assembly at the operator’s back. Right Hand (RH) and Left Hand (LH) sides of the sprayer are determined as if you are standing behind the sprayer,...
  • Page 4 Step 4 Assembly Procedure (LG-25-BL-ATV) End Nozzle Assembly Procedure For Boomless “Wet”Boom Your boom will come with the (2) end nozzle assemblies NOT affixed to your boom tube. Follow the instructions below to attach these properly to the boom tube, as shown.
  • Page 5 Step 5 Assembly Procedure (LG-25-BL-ATV) After your boom is attached, locate the 48” hose and the (2) hose clamps from the parts bag. Place the hose clamps over each end of the hose loosely. Slip the ends of the hose over the hose barbs on both the manifold and on the center nozzle.
  • Page 6: Operation

    IMPORTANT: Remove tank lid and be sure the tank is clean and free of Manifold Valves CLOSED any foreign material. Rinse tank out of any tank residue before filling with water to test. Testing the Sprayer NOTE: It is VERY important for you to test your sprayer with plain water before actual spraying is attempted.
  • Page 7: Speed Chart

    Drain and then refill half full, add the recommended amount of a good quality tank cleaner, such as FIMCO Tank Neutralizer and Cleaner. (If no tank cleaner is available, you may substitute dish soap for this step, about 1-2 oz. per gallon).
  • Page 8: Troubleshooting The Pump

    1/2” Hose Barb Port Kit Fitting #5168833 DON’T  Use to pump bleach.  Clean and rinse your pump after each use with Fimco Tank  Use to pump petroleum products such as diesel fuel, Neutralizer gasoline or kerosene ...
  • Page 9 Checking the Pressure Switch If your motor is not running and you’ve checked the following: for loose wiring connections, fuse, the switch on the lead wire was “ON” and made sure you were connected to a fully charged battery and everything is fine, but the motor won’t run, then it’s time to check to see if the pressure switch is bad.
  • Page 10 Manifold Detail 5278781 Intake Detail 5275877 Exploded View/Parts List: LG-25-BL-ATV (5302952) Page 10...
  • Page 11 Boomless “Wet” Boom Assembly End Nozzle Assembly Center Nozzle Assembly 5275123 5275122 Page 11...
  • Page 12: Warranty

    WHAT REMEDIES ARE AVAILABLE UNDER THIS LIMITED WARRANTY. If the conditions set forth above are fulfilled and the Equipment or any part thereof is found to be defective, Fimco, Ind. shall, at its own cost, and at its option, either repair or replace the defective Equipment or part.