Table of Contents
Advertisement
3. Connection
4. Location and Function of Switches/LEDs
3-3.
Signal Input/Output
Input and output signals of connector on the connector
panel are shown below.
REMOTE:RS-422A (D-sub 9-pin, Female)
5
1
9
6
<External View>
Pin No.
1
2
3
4
5
6
7
8
9
1-6 (E)
Signal
FRAME GROUND
TX–
RX+
GROUND
SPARE
GROUND
TX+
RX–
FRAME GROUND
4.
Location and Function of Switches/
LEDs
4-1.
ENC-29 Board
1
2
D3303
3
D3304
4
D3305
D3307
5
D3306
6
D3308
7
D3301
8
S3001
9
S3301
0
S3000
!-
CN1101
n
• Do not change the setting of the switches described as
"Factory use only".
• ( ) mark followed by the Ref No. shows the address of
switch or indicator on the board.
1 D3303(A-3) :System Error indicator
When an error is detected in the system control, it
lights in red.
2 D3304(A-3) :Video Error indicator
When an error is detected in the video block, it lights
in red.
3 D3305(A-4) :Audio Error indicator
When an error is detected in the audio block, it lights
in red.
4 D3307(A-4) :Test SG indicator
When the test signal generator operates in the board, it
lights in green.
5 D3306(A-4) :Input Error indicator
When an illegal signal is detected in the SDI input
connector, it lights in red.
6 D3308(A-4) :Test indicator
In the test mode (when S3000-8 is set to ON), it lights
in green.
7 D3301(A-5) :Monitor indicator
While running the monitor program, it lights in red.
<Component side/A side>
BKSI-2020
Advertisement
Table of Contents
