Toto Washlet E200 Installation Instructions

Before installing your Washlet, be sure to read the following installation instructions and install the product only as described in this manual.
The symbol indicates a prohibited use of the product.
Do not install the Washlet in a wet or damp
place, such as a shower stall or bathtub
area. Doing so may cause fire or electrical
Prohibited
Use of This shock.
Product:
Only use tap water or drinkable well water
(ground water).Use of water that is not safe
for drinking may cause irritation or injury to
the skin.
Do not remove the
drain valve and water
filter with the water
shutoff valve in the
OPEN position.
1. Do not transmit electrical current or supply water to the unit until
the installation process is complete.
2. The power voltage is 120V/60Hz. The rated energy consumption
is 410 W. Use wiring and electrical outlet appropriate for this level
of power.
3. The power cord is 3 feet (1m) in length. The electrical outlet
should be installed on the wall to allow easy installation and
removal of the Washlet .
Parts and Features
Lid
Label
Toilet seat sensor
Main unit
Junction valve
Power plug
Connection hose
Washlet E200 Installation Instructions
Safety Precautions
This product should be used with grounded
120V, 60Hz electrical current only to avoid
possible fire or shock.
Do not use a loose or faulty electrical outlet
or plug.Doing so may cause fire or electrical
shock.
After cleaning the water
filter, be sure to insert it
into the drain valve and
securely tighten the drain
valve to avoid water leak-
age.
Before Installing the Washlet
Water drainage
plug
Release button
for removing the
main unit
Heated toilet seat
Wand
Base plate
Remote controller
This symbol means "Always follow this precaution".
DANGER
WARNING
Do not bend or crush the
Do not raise the toilet seat or
connection hose.Bending
seat cover while objects are
or crushing the connec-
resting on top of the toilet, as
tion hose may result in
this could cause the main unit
water leakage.
to become detached, resulting
in injury.
4. Use a water supply of 20 - 80 PSI (0.14Mpa ~ 0.55Mpa).
5. The water temperature range should be 0 ~ 35 ° C (32~95 ° F).
6. The length of the connection hose is 1.5 feet (500mm). The water
supply should be installed to allow easy installation and removal of
the Washlet.
Parts Identification
‚ Washlet Main Unit
Base Plate Parts
˜
Bolts (2)
Washers (round, 2)
Washers (lock, 2)
Stopper (2)
Base Plate
Rubber bushing (2)
› Instruction Manual
Warranty Card
Installation Instructions
Follow all safety precautions and warnings when
installing the Washlet.
Make sure that a ground wire has been
installed. Failure to install a ground wire
could result in electrical shock in the event of
a malfunction or short circuit.
Be sure to plug the electrical cord all the way
into the wall socket to avoid possible fire or
electrical shock.
— Remote Controller Parts
Remote controller
Anchor bolts (3)
Screws (3)
Connection Hose
™
(with packing washer)
Template
Use second set of mounting holes for
decoratively curved toilets.
Washers (2)
œ ‰
2004.9.27 D06694S
Do not install base
plate to Washlet
when not attached
to the toilet. Fire or
damage may result.
Remote controller
wall hanger
Remote controller batteries
(2 AA batteries)
Junction valve
š
Optional Elbow Joint