ergolet Luna Replacement Manual

a
l i f t t h e w o r l d
To replace Luna batteries you will need the following tools:
ü Side cutters
ü Screwdriver PZ 1x 75 (Philips type)
ü Hexagonal (Allen) key 2 mm
Run the strap approx. 1meter out before commencing the
replacement.
Battery set: xxxxxxx
Remove Luna from the track, lay it on a table with the bayonet side
up.
Activate the emergency stop, remove the hand control from the
Luna cassette.
Unscrew the screws from the plastic bracket around the bayonet
inlet (4 pcs.)
Pull up on the lid (shell) at the side foils to remove it.
Carefully remove the side foils from their position in the lower shell.
Remove the lower lid (shell) in the same way as the upper lid.
Turn the Luna unit around so that the bayonet side is upward again.
Remove the small screw (a) (M3 x 5) which holds the print card, cut
the wire ties holding the print card and battery.
Carefully pull the print card upwards until the large plug next to the
b
fuse can be seen. Press the holder and remove the plug(b).
Det gamle batteri kan nu fjernes.
The new velcro and ties to hold the battery are mounted.
See procedure for replacing batteries on the back of this guide
Teknisk dokument / Udskiftning af batteri UK gælder for Luna / Dato 2004.10.01 / Version 1
Replacement
guide
Batteries