Sealey AK437.V2 Instructions

4. MAINTENANCE
4.1. CHANGING THE SPOTLIGHT BULB
" WARNING! Ensure the spotlight is turned off and the lens has cooled
prior to changing the bulb.
1. Undo the spotlight hood (fig.1.A) by turning it anti-clockwise.
2. Carefully lift the reflector assembly revealing the spring clip (fig.5.1)
and the cable connector (fig.5.2).
3. Disconnect cable (fig.5.3).
4. Remove the spring clip (fig.5.1).
5. Pull bulb (fig.5.4) outward from the reflector.
6. Hold the new bulb with a lint free cloth, (do not handle the bulb),
install by reversing the above procedure.
" WARNING! Beware of causing a short circuit.
4.2. CHANGING THE BATTERIES
WARNING! Ensure you read, understand and apply safety
" "
instructions relating to the battery before changing.
1. Undo the spotlight hood (fig.1.A) by turning it anti-clockwise.
2. Carefully lift the hood and reflector assembly revealing the four
battery cover retaining screws (fig.6.1)
3. Disconnect wire (fig.6.3a) from bulb cable (fig.6.3b) .
" WARNING! Beware of causing a short circuit.
4 Undo the four retaining screws.
5. Carefully raise the battery cover (fig.6.2).
6. Carefully remove battery terminal wires, noting cable connections,
then remove both batteries.
7. Replace with genuine Sealey batteries and install by reversing the
above procedure.
Notes: a) Take care not to pinch or misconnect any wires.
b) When replacing battery cover make sure that charging jack PCB
is slotted into supports before replacing screws.
8. Dispose of old batteries in accordance with local authority lead-
acid battery regulations. DO NOT dispose of with regular refuse.
fig.5
Declaration of Conformity
We, the sole importer into the UK, declare that the products listed here are in
conformity with the following standards and directives. The construction files
for these products are held by the Manufacturer and may be inspected, by a
national authority, upon request to Jack Sealey Ltd.
Rechargeable Spotlight
Model AK437.V2
73/23/EEC Low Voltage Directive
89/336/EEC EMC Directive
2002/95/EC RoHS Directive
2002/96/EC WEEE Directive
For Jack Sealey Ltd. Sole importer into the UK of Sealey Power Products.
NOTE:
It is our policy to continually improve products and as such we reserve
the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this equipment.
WARRANTY: Guarantee is 12 months from purchase date, proof of which
will be required for any claim.
INFORMATION: For a copy of our latest catalogue and promotions call us
on 01284 757525 and leave your full name and address, including postcode.
01284 757500
01284 703534
Thank you for purchasing a Sealey Product. Manufactured to a high standard this product
1
will, if used according to these instructions and properly maintained, give you years of
trouble free performance.
1.1. GENERAL
fig.6 ! Ensure the spotlight is correctly charged before initial use.
! When fully charged, spotlight must not be used for more than 20 minutes
" WARNING! The lens becomes very hot during operation.
# DO NOT cover or block the lens during use.
# DO NOT turn the spotlight on when it is being re-charged.
# DO NOT shine directly into your, other person's or animal's eyes.
# DO NOT stand the spotlight near any surface or item that may be adversely
# DO NOT allow children to use the spotlight.
# DO NOT handle or move the spotlight whilst it is being charged.
# DO NOT use the spotlight if you suspect that the battery or the spotlight
Signed by Mark Sweetman
# DO NOT handle lamp bulb with your fingers. Use a soft lint-free cloth.
! Ensure that correctly rated battery and bulb are used for replacements.
30th July 2007 ! When not in use store the spotlight in a safe, dry, childproof location.
1.2. BATTERY SAFETY
DANGER!
NOT HANDLED WITH CARE AND ACCORDING TO THESE
! Before exposing the batteries for replacement, remove personal metallic
# DO NOT smoke or allow a spark or flame in the vicinity of batteries.
! Ensure the charger is switched off and disconnected from the
! If the batteries' terminals are corroded or dirty, clean them before
# DO NOT dis-assemble the batteries for any reason.
" WARNING! DO NOT allow metal tools to touch both battery terminals
# DO NOT allow battery wires to touch each other or to make contact
Sole UK Distributor
# DO NOT leave batteries in a discharged state, recharge batteries
Sealey Group,
Bury St. Edmunds, Suffolk.
# Dispose of the old batteries in accordance with local authority battery
www.sealey.co.uk
Web
sales@sealey.co.uk
email
INSTRUCTIONS FOR:
RECHARGEABLE SPOTLIGHT
5,000,000 CANDLE POWER
AK437.V2
Model:
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE
THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS AND CAUTIONS.
USE THIS PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE
FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE
AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY.
PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY INSTRUCTIONS
continuously. To do so may damage the lamp.
effected by the heat emitted by the lens.
casing is damaged.
BE AWARE, LEAD-ACID BATTERIES MAY BE DANGEROUS IF
items such as rings, bracelets, necklaces and watches. A lead-acid
battery can produce a short-circuit current high enough to weld a ring
to metal, which would cause severe burns.
spotlight before attempting to open the lamp unit.
replacing batteries.
simultaneously. Arcing or short circuit will result.
with any other metallic part.
immediately. If the spotlight is not in use, recharge the batteries every
three months.
regulations. DO NOT dispose of with regular refuse.
INSTRUCTIONS.,
AK437.V2 - 1 - 300707